Operating instructions

50
CONTRCONTR
CONTRCONTR
CONTR
OL DESCRIPTIONOL DESCRIPTION
OL DESCRIPTIONOL DESCRIPTION
OL DESCRIPTION
POWER SWITCHPOWER SWITCH
POWER SWITCHPOWER SWITCH
POWER SWITCH
Located lower center of control.
Turns air conditioner or gas furnace ON to set condition.
Turns air conditioner or gas furnace OFF.
Green LED lights next to MODE switch light up to indicate
power ON.
No LED lights on when control is OFF.
MODE SWITCHMODE SWITCH
MODE SWITCHMODE SWITCH
MODE SWITCH
Four position switch located on right side of control.
Used to select COOLING, FAN or GAS HEAT mode of
operation.
Mode selected is indicated by green LED light when control
is turned on.
FAN SWITCHFAN SWITCH
FAN SWITCHFAN SWITCH
FAN SWITCH
Four position switch located on left side of control.
Used to select HIGH, MEDIUM, LOW or AUTOMATIC
FAN operation of air conditioner
Fan speed selection is indicated by green LED light when
control is turned on.
TEMPERATURE SLIDETEMPERATURE SLIDE
TEMPERATURE SLIDETEMPERATURE SLIDE
TEMPERATURE SLIDE
Located top center of control.
Movable arm on control selects temperature at which the
compressor or gas heat is turned ON and OFF.
User sets to position to maintain temperature level desired.
BY DOMET IC DUO-THERM
ELEC HEAT
807060
GAS HEAT
POWER
LOW
MED
HI
AUTO
COOL
FAN
EXAMPLE
TEMPERATURE
CONTROL SL IDE
FAN L EDs
(Green)
MODE L EDs
(Green)
MODE SW ITCH
POWER
SWITCH
R
IBBON C ABLE C ONNECTION
ON R EVERSE S IDE
FAN
SWITCH
COOLING MODE OPERATIONCOOLING MODE OPERATION
COOLING MODE OPERATIONCOOLING MODE OPERATION
COOLING MODE OPERATION
Turn POWER switch to ON position.
Place mode switch to COOL position.
Set temperature slide switch to your desired temperature
level.
Select your desired fan speed. NOTE: See Special Fea-
tures Section for AUTO Fan Operation.
The fan starts immediately and after a delay of approxi-
mately two minutes, the compressor will start.
The compressor will now cycle OFF per the thermostat set
point. The fan will:
a. Continue to operate in the selected fan speed if
AUTO FAN position is not selected.
b. Cycle OFF and ON with the compressor cycle if
AUTO FAN position is selected.
The compressor (and fan) will restart in approximately two
minutes after the thermostat senses the need for cooling.
FAN MODE OPERATIONFAN MODE OPERATION
FAN MODE OPERATIONFAN MODE OPERATION
FAN MODE OPERATION
Turn POWER switch to ON position.
Place MODE switch in either FAN position.
Select the desired fan speed: HI-MED-LOW-AUTO.
NOTE: In AUTO position the fan operates only at low speed
in the FAN mode of operation.
BY DOMET IC DUO-THERM
ELEC HEAT
8070 60
GAS HEAT
POWER
LOW
MED
HI
AUTO
COOL
FAN
EXAMPLE
TEMPERATURE SL IDE SET
AT 70 DEGREES
GREEN L ED ON
NEXT TO COOL
INDICATOR
POWER
SWITCH
IN ON
POSITION
MODE SW ITCH SET
TO FA N POSITION
GREEN L ED
NEXT TO MED
FAN INDICATOR
FAN SW ITCH SET T O
MEDIUM FAN P OSITION
BY DOMET IC DUO-THERM
ELEC HEAT
8070 60
GAS HEAT
POWER
LOW
MED
HI
AUTO
COOL
FAN
EXAMPLE
NEXT TO FA N
INDICATOR
FAN SW ITCH SET T O
HIGH FA N P OSITION
GREEN L ED
NEXT TO HI
FAN INDICATOR
POWER
SWITCH
IN ON
POSITION
MODE SW ITCH SET
TO FA N P OSITION