Operating instructions

ManualsBrandsDometic ManualsHeat Pump630025

6E. BIMETAL CONTROLS

This type of heat pump is controlled by a Bimetal type wall

thermostat. The air distribution can be an air distribution

box or a ducted air system.

NOTENOTE

NOTE: Remember to check the installation and operating

instructions for the specific model you are diagnosing.

BIMETAL THERMOSTAT OPERATION:BIMETAL THERMOSTAT OPERATION:

BIMETAL THERMOSTAT OPERATION:

COOLING:COOLING:

COOLING:

A. Set the System Switch to Cool;

B. Set the Temperature Lever to your comfort level.

C. Set the Fan Switch to:

AUTOAUTO

AUTO: The fan will cycle off and on with the

compressor.

ONON

ON: The fan will run continuously. The com-

pressor will cycle off and on with the thermostat

demand.

HEATINGHEATING

HEATING

A. Set the System Switch to HEAT PUMP.

B. Set the Temperature Lever to your comfort level.

C. Set the Fan Switch to:

1) AUTO: The fan will cycle off and on with the

compressor.

2) ON: The fan will run continuously. The com-

pressor will cycle off and on with the thermo-

stat.

BIMETALBIMETAL

BIMETAL

AUXILIARY HEATAUXILIARY HEAT

AUXILIARY HEAT:

A. Set the System Switch to AUX. HEAT.

B. Set the Fan Switch to AUTO.

C. Set the temperature lever to your comfort level.

NOTE: The auxiliary heat position is only used if:

1) You have a factory installed furnace operating from

the heat pump system thermostat.

2) The outside temperature is above 40°F. and you

wish to operate your furnace.

3) For quick interior warm-up.

4) There is no 115 volt AC power available to operate

your heat pump and you must operate the furnace

for your comfort.

FAN:FAN:

FAN:

To circulate air without heating or cooling:

A. Set the System Switch to OFF.

B. Set the Fan Switch to ON.

HIGH/LOW:HIGH/LOW:

HIGH/LOW:

HIGH: Fan speed position.

LOW: Fan speed position.