Product Manual

EN
FanTastic Vent Installing the device
17
6.1 Pressing out the hole
See fig. 2, page 4
6.2 Using the reinforcing rails
Proceed as follows (fig. 3, page 4):
➤ Before installation, check whether the roof opening needs reinforcing.
➤ Remove the foam according to the width of the reinforcing rails (not in scope of
delivery) (A).
➤ Fit the reinforcing rails (B).
7Installing the device
!
➤ Run the 12 V connection through the roof.
➤ Trim the inner frame depending on the thickness of the roof (fig. 4, page 4).
➤ Check that the roof light has sufficient space around it (approx.1 to 2 mm) in the
roof opening (fig. 5, page 5).
➤ Clean the roof opening in the mounting area (fig. 6, page 5).
➤ Place a gasket or sealant around the roof opening (fig. 7, page 5).
➤ Check the direction of travel when installing (fig. 8, page 6).
➤ Make sure the cover hood hinge is towards the direction of travel.
➤ Place the roof light into the middle of the roof opening (fig. 8, page 6).
➤ Connect the cable to the 12 V connection (fig. 9, page 7).
➤ Check the fan works properly.
➤ Screw the roof light to the roof tightly. Use all the screw holes provided to do this
(fig. 0, page 7).
➤ Seal the roof light (fig. a, page 8).
➤ Seal the screw heads (fig. a, page 8).
WARNING! Beware of injury!
Disconnect the vehicle power supply before you begin and make sure it
cannot be restarted.
FanTastic-Vent-IO-16s.book Seite 17 Freitag, 5. Mai 2017 11:41 11
“More information https://www.caravansplus.com.au"