Installation Guide

11
FIG. 21
RH End Cap
Awning
Safety
Lock
Nail
F. Secure Awning Fabric To Awning Rail
1.  PINCH HAZARD. Maintain a
horizontal distance of at least 16″ between fully
open awning and any permanent object. Failure
to obey this caution could result in injury.
Open and close awning four or ve times to al-
low for natural self adjustment of awning fabric.
See Operating Instructions.
2. Verify alignment of awning fabric, and awning
hardware.
a. If there is misalignment, make adjustments
accordingly.
b. Cycle awning again to check alignment.
3. Ensure arm assemblies are still positioned cor-
rectly (directly in front of top brackets), then mark
location of awning fabric edges on awning rail.
4. Pull one edge of awning fabric approximately
1/4″ beyond marked position. Then secure with
#6 X 7/16″ TEK screw through awning rail (ap-
proximately 2″ from fabric edge). See (FIG. 22).
FIG. 22
2″
Awning Rail
Fabric Edge
#6 X 7/16″
TEK Screw
5. Pull to stretch opposite edge of awning fabric
approximately 3/4″. Then secure with #6 X 7/16″
TEK screw through awning rail (approximately
2″ from fabric edge).
INSTALL AWNING
VERIFY INSTALLATION
A. Test Operation
Operate awning according to Operating Instruc-
tions to verify all parts are functioning correctly.
B. Secure Awning For Travel
1. Fully close awning. See “Close Awning” in Oper-
ating Instructions.
2. Verify awning is secure for travel. See “Prepare
Awning For Travel” in Operating Instructions.
C. Keep Literature
Instructions contain valuable information for prod-
uct use and consumer safety.

Keep BOTH the Installation and Operat-
ing Instructions with product.