Product Manual

EN
PW1000, PW1500 Operating the awning
13
7 Operating the awning
Observe the safety instructions in chapter “Safety instructions” on page 9.
7.1 Note on the vehicle location
A
7.2 Extending the awning
!
➤ Click the hand crank into the holder in the awning (fig. 1, page 3).
➤ Turn the hand crank until the awning is extended by about 1.5 m (fig. 2,
page 3).
➤ Slide the right strut into the front cover completely together so that you
can move them freely (fig. 3, page 4).
➤ Turn the right strut to the side (fig. 3, page 4).
➤ Fold the right strut down and set it on the ground (fig. 4, page 4).
➤ Adjust the strut to the required height (fig. 5, page 5).
➤ Fold the lever of the strut up to secure the struts (fig. 6, page 5).
➤ Extend the other strut in the same way.
➤ Turn the hand crank until the awning is extended to the required position.
Position the strut vertically under the front cover regularly so that the
awning stays secured at all times.
➤ Turn the hand crank approx. a quarter of the way back to tighten the
fabric.
NOTICE!
 Park the vehicle so that no debris (branches, leaves or similar)
gets on to the fabric.
 Keep the awning free of dirt to prevent abrasions, stains and
mildew.
WARNING! Beware of injury
Keep a sufficient distance from objects or other vehicles. Once it
is retracted, it should be at least 40 cm away from other objects
and vehicles.