Product Manual

EN
PW1000, PW1500 Operating the awning
15
7.3 Retracting the awning
A
➤ Remove any debris (branches, leaves or similar) lying on the fabric.
➤ Loosen the struts from the fastenings (pegs or latches on the vehicle).
➤ Click the top end of the hand crank into the holder in the awning.
➤ Turn the hand crank until the awning is extended by only about 1.5 m.
Position the struts vertically under the front panel regularly so that the
awning stays secured at all times.
➤ Fold the lever of the right strut down to loosen the struts.
➤ Slide the struts together completely.
➤ Fold the right strut up.
➤ Turn the right strut into the front panel.
➤ Slide the bottom part of the right strut into the latch of the front panel.
➤ Extend the other strut in the same way.
➤ Turn the hand crank until the awning is fully retracted.
➤ Double-check that the awning is fully retracted before starting your
journey. The front panel should rest closely alongside the housing.
➤ Remove the hand crank from the holder on the awning.
A
NOTICE!
 Only retract the awning, when the fabric is free of debris
(branches, leaves or similar). Otherwise, the awning can be
damaged when it is retracted.
 Keep the awning free of dirt to prevent abrasions, stains and
mildew.
 When retracting the awning, make sure that any branches or
other objects are not trapped in it.
NOTICE! Risk of damage!
If the awning is retracted when wet, extend it again at the next
opportunity and let the fabric dry out. If the wet fabric stays rolled
up for a long time it becomes mildewed and can fade.