Product Manual

PR2000, PR2500 Connecting the awning (only PR2500)

7 Connecting the awning (only PR2500)

There are two options for the electrical connection of the awning:

• Awning switch with an integrated main switch

• Main switch and receiver for the remote control

Observe the following installation instructions:

• Fit the supplied main switch and fuse (15 A) to the positive line of the power

supply. The main switch is required to switch off the awning when side walls are

fitted to the awning, for example, or if the vehicle is taken out of service for an

extended period of time (otherwise the standby consumption may drain the

battery).

• Install the receiver on the inside of the vehicle to protect it from moisture.

• Observe the length of the cable between the awning motor and receiver when

choosing a place to install it.

• Do not shorten the antenna cable.

• Connect the ignition (D+ signal) to the orange line of the receiver. This is the only

way to ensure that the awning cannot be opened while driving.

• When installing the supplied plug, use a suitable tool (crimping tool) to ensure

that the connection is secure and durable.

• If you want to connect an awning light (accessory), make sure that its maximum

power consumption is 30 W. When connecting, make sure the polarity is

correct.

WARNING!

• Disconnect the power supply before starting the assembly.

• Only permit a qualified electrician to connect the awning to the elec-

trical power.

CAUTION!

The cables and cabinets in the interior of the vehicle must not be

damaged through drilling the holes.

PR2000_PR2500-I-16S.book Seite 17 Donnerstag, 5. Oktober 2017 10:15 10