Manual

EN
Connecting the device MCA1215, MCA1225, MCA1235
18
Charging the battery
➤ Connect the battery to the “DC OUTPUT” socket of the MCA battery
charger.
 Make sure the polarity of the connections is correct.
Charging the starter battery
➤ Connect the starter battery to the “ESB” socket of the MCA battery
charger.
 Make sure the polarity of the connections is correct.
Charging using the temperature sensor MCA-TS1 (accessory)
➤ Connect the temperature sensor to the TEMP/LIN connection.
✓ The charging voltage is adjusted according to the temperature measured.
Charging using the IBS battery sensor MCA-HS1 (accessory)
➤ Connect the battery sensor to the TEMP/LIN connection.
✓ The battery sensor transmits the battery temperature and the battery
voltage to the charger via the LIN communication port. The charging
voltage is regulated according to the temperature. Any potential loss of
voltage in the connecting cables is also compensated.
Charging using the battery management system PerfectControl
MPC01 (accessory)
➤ Set the DIP switches 1 to 3 on the MCA battery charger to “ON” (chapter
“Setting the DIP switches” on page 23).
You can find detailed information in the operating manual for MPC01.