Service manual

16
- Position element, adjust its position. The element must be positioned in the
direction of hinge. (Fig. 65)
- Reinsert boiler-insulation, secure.
- Reinsert boiler-insulation cover, bend back blocking tabs. (Fig. 66)
- Reinsert temperature controller
- Snap back wire clamp of heating element. (Fig. 67)
- Reassemble loosened end of hinge
- Check electrical insulation resistance according to 2.3.3.
2.3.5 Replacing temperature sensor
- Remove electrical cover. (See 2.3.3)
- Push off flat sockets of temperature sensor from the flat connectors of
printed circuit board. (Sensor)
- Open refrigerator door, remove plugs from two bores of sensor cover in the
inner compartment, set aside. (Fig. 68)
- Unscrew screws of sensor cover, lift out sensor from cover. (Fig. 69, 70)
- Pull out sensor wire towards inner compartment carefully, so that the flat
sockets do not get jammed in the lead rubber gasket. (Fig. 71, 72)
Figure 65 Figure 66 Figure 67
Figure 68 Figure 69 Figure 70
Figure 71 Figure 72