Service manual

19
- Reinstall thermostat case onto the new thermostat, secure with nut. During
assembly make sure that the navigation-securing pin of thermostat fits into
the bore of plate. (Fig. 86)
- Reinsert thermostat onto panel, secure with screws.
- Reassemble thermostat wires.
- Reinsert thermostat cover, secure.
- Insert thermostat capillary into cabinet approx. 200 mm deep. (Fig. 87)
- Place refrigerator in upright position.
- Insert thermostat capillary into cooling flange approx. 200 mm deep.
- Reinsert cooling flange, carefully positioning thermostat capillary, then
secure with 4 plate screws (the original corrosion-proof screws should be
used).
- Push thermostat switch back onto the shaft of thermostat. When
positioning, make sure that the shaft jointing fits with the switch bore
jointing. (Fig. 88)
Fi
g
ure 84 Fi
g
ure 85
Fi
g
ure 86
Figure 87
Figure 88