Operating Manual
Table Of Contents
- 1 Explanation of symbols
- 2 Safety instructions
- 3 Scope of delivery
- 4 Accessories
- 5 Intended use
- 6 Function description
- 6.1 Scope of functions
- 6.2 Operating and display elements
- 7 Operation
- 7.1 Before initial use
- 7.2 Energy saving tips
- 7.3 Reversing the lid opening direction
- 7.4 Connecting the cooler
- 7.5 Using the cooler
- 7.6 Using the display
- 7.7 Locking/unlocking the display
- 7.8 Selecting the temperature units
- 7.9 Setting the temperature
- 7.10 Using the battery protection
- 7.11 Setting the display‘s brightness
- 7.12 Switching on or off the compartments (only CFX 3 75DZ, CFX 3 95DZ)
- 7.13 Using the ice maker (only CFX 3 55IM)
- 7.14 Downloading the CFX3 app
- 7.15 Setting the Bluetooth signal and connecting to the app
- 7.16 Setting the WiFi signal and connecting to the app
- 7.17 Changing CFX name and password in the app
- 7.18 Resetting the app password (WiFi only)
- 7.19 Resetting to factory settings
- 7.20 USB port for power supply
- 7.21 Defrosting the cooler
- 7.22 Replacing the AC fuse
- 7.23 Replacing the DC fuse
- 7.24 Replacing the DC plug fuse
- 7.25 Replacing the light PCB
- 8 Cleaning and maintenance
- 9 Troubleshooting
- 10 Warranty
- 11 Disposal
- 12 Technical data
EN
CFX3 Cleaning and maintenance
33
8 Cleaning and maintenance
A
➤ Occasionally clean the device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any dust and
dirt, so that heat can be released and the device is not damaged.
9 Troubleshooting
NOTICE! Damage hazard
• Never clean the cooler under running water or in dish water.
• Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the cooler.
Fault Possible cause Suggested remedy
The device does not
function (DC mode,
ignition on).
No voltage was
detected in the
DC power outlet.
In most vehicles the ignition must be
turned on before power will be supplied
to the DC power outlet.
The DC outlet is dirty.
This results in a poor
electrical contact.
If the plug of the device becomes very
warm in the DC outlet, either the
DC outlet must be cleaned or the plug
has not been assembled correctly.
The fuse of the DC plug
has blown.
Replace the fuse in the DC plug, see
chapter “Replacing the DC plug fuse” on
page 32.
The device DC fuse has
blown.
Replace the device DC fuse, see chapter
“Replacing the DC fuse” on page 32.
The vehicle fuse has
blown.
Replace the vehicle’s DC outlet fuse.
Please refer to your vehicle’s operating
manual.
The device does not
function (AC mode).
No voltage present in
the AC voltage socket.
Try using another plug socket.
The device AC fuse has
blown.
Replace the device AC fuse, see chapter
“Replacing the AC fuse” on page 32.
The integrated AC
adapter is defective.
This can only be repaired by an
authorised repair centre.
CFX3_OPM_APAC(en).book Seite 33 Mittwoch, 24. Juni 2020 11:07 11