User manual

- 2 -
3%
PLACERING
Spisfläkten är avsedd för husvagnar, husbilar och båtar och
placeras ovanför matlagningsplatsen, lämpligen inbyggd i be-
fintligt överskåp. Avståndet från gaskökets låga till spisfläktens
underkant skall vara minst 50 cm.
Ventilatordelen A-B-C skall placeras i taket på en så jämn och
horisontell yta som möjligt. Placeras ventilatorn på ett lutande
underlag skall delen A vridas så att en av de tre vattenavrin-
ningsöppningarna riktas nedåt. En lutning på upp till 20°
kan accepteras utan att ventilationen vid stillastående motor
försämras.
SÅ HÄR MONTERAS SPISFLÄKTEN
Tag upp ett hål med 105 mm diameter på husvagnens tak.
Lägg på underdelen A och märk upp de sex hålen.
Tag bort underdelen A och lägg en tunn ring av något
plastiskt kitt runt varje hål.
Lägg därefter in gummiringen i spåret, på undersidan av
A. Det är viktigt att underdelen dras fast ordentligt så att
gummipackningen tätar mot taket.
Skruva fast kåpan B i underdelen A.
Skruva därefter fast överdelen C i underdelen A.
Tag upp ett hål i skåpets botten enligt måttskissen 2.
Skruva fast fläktkåpan D. Trä på slangen på fläkten och
kåpan. Drag fast slangen med slangklämmorna.
Anslut fläkten till batteriet enligt figuren.
FLÄKTFILTRET
Fläktfiltret som absorberar det fett som finns i matoset, behöver
då och då göras rent. Hur ofta det skall ske beror naturligtvis på
matvarorna och på hur mycket fläkten är i gång. Vänta inte tills
fläktens sugförmåga avtar. Rengöringen sker lätt med varmvat-
ten tillsatt med något syntetiskt tvättmedel.
TEKNISKA DATA
Motoreffekt 30 W
Spänning 12 V
Kapacitet 115 m
3
/h
Belysning 20 W, 12 V GU5,3
Extern belysning Max. 20 W
1.
2.
3.
4.
5.
6.
7.
8.
9.
%.
PLACING
The ventilator is for use in caravans, motorhomes and boats
and designed to be placed above the food preparation area,
preferably built-in to an existing top cupboard. The distance
from the gas-stove flame to the lower edge of the cooker hood
must not be less than 50 cm.
The ventilator part A-B-C should be placed in the roof, on
a surface that is as even and horizontal as possible. If the
ventilator is positioned on a sloping surface, the part A should
be rotated so that one of the three drainage openings points
downwards. An inclination of up to 20° is acceptable without
reducing the ventilation when the motor is not running.
FITTING THE VENTILATOR
Make a hole with a diameter of 105 mm through the roof
of the vehicle.
Place the ventilator part A in the hole and make a mark of
the six screw holes.
Remove part A and apply a thin ring of some permanently
plastic sealing compound around each hole.
Put the rubber ring into the groove underneath of part A. It
is important that the lower part should be firmly tightened
so that the rubber gasket fits closely against the roof.
Fasten the hood B in the lower part A.
Then fasten the upper part C in the lower part A.
Make a hole in the bottom of the cupboard as shown on
the dimension sketch 2.
Fasten the ventilator hood D with screws and fit the hose
to the fan and hood, tighten the hose with the hose clips.
Connect the fan to the battery according to the figure.
THE FAN FILTER
The fan filter that absorbs grease in cooking fumes requires
cleaning now and then, how often depends on how much the
cooker is used and for how much the fan is in operation. Do
not wait until the suction power of the fan begins to decrease
noticeably. Cleaning can easily be carried out with hot water to
which some synthetic detergent has been added.
TECHNICAL DATA
Motor power 30 W
Voltage 12 V
Capacity 115 m
3
/h
Light 20W, 12V GU5,3
External light Max. 20 W
1.
2.
3.
4.
5.
6.
7.
8.
9.