User manual

5
3. Cleaning
Clean the refrigerator thoroughly at intervals, as
necessary. Remove the shelves; these, the
cabinet interior and the door should be washed with a
warm solution of sodium bi-carbonate. Finally wipe
over with a cloth rinsed in warm water only, and dry
with a clean cloth. Do not wash any plastic parts in
water that is more than hand warm, and do not expose
them to dry heat. The outside of the cabinet should be
wiped down regularly with a clean, damp cloth.
NEVER USE STRONG CHEMICALS OR ABRASIVE
CLEANING MATERIALS ON ANY PART OF THE
CABINET.
4. Positioning the appliance
When first using this refrigerator please consider the
following points:
ENSURE REFRIGERATOR IS LEVEL
THE PARTS AT THE BACK GET HOT IN USE
ALLOW AT LEAST 3 HRS. FOR SIGNS OF
COOLING
During the refrigeration process, the appliance
gives up the heat at the back side into the
surrounding air. The more ventilated the back side is,
the more effective the refrigeration will be.
It is important that the appliance is not directly
exposed to radiated heat (sunlight, radiator, near an
oven, etc.).
4.1. Installation instructions
The refrigerator is equipped with a thermoelectric
module. If it will be built in, please follow the important
instructions below:
IMPORTANT
Please follow the installation details below
carefully Guarantee is valid for products installed
as described only.
1. The refrigerator must staying on an even
surface.
2. There should be 20mm clear
ance to the wall
3. Ventilation must be provided as shown in
alternatives A, B, C or D (fig 2-3)
4. The ventilation duct must at least measure
105mm x the width of the refrigerator
5. Only
the entire warm part must project into the
duct as shown
6. Air passing thr
ough the duct must not be
preheated by any source of heat
7. Ventilation grills, if used, must have an open
square of at leas
t 200cm
2
each
Figure 2.
Figure 3.
The refrigerator must be fixed to the bottom of the
furniture through its fixing feet using screws of an
appropiate length. (Fig. 4)
Figure 4.
During installation, please ensure the mains
plug is accessible at all times.
5. Using the appliance
To start the refrigerator connect the plug to the socket
outlet and switch on the refrigerator. The cooling fins
should show signs of cooling after about 3 hours.