User manual

6
The refrigerator needs about 6 hours at normal
ambient temperature to reach 6 °C in the storage
compartment.
5.1. Temperature regulation
The temperature of the miniCool is pre-setted to
approximately +5 °C at +25 °C ambient temperature.
If the ambient temperature will change, the inside
temperature will also be changed.
Figure 5.
6. Useful suggestion
Do not overfill the appliance. It is advisable to leave
some space between the products in the cabinet to
ensure efficient and even cooling. If the shelves are
packed too tightly there may be unacceptable
temperature variations.
7. Defrosting, cleaning and
maintenance
Frost will gradually form on the cooling fins and it must
not be allowed to become too thick since it acts as an
insulator and interferes with the cooling.
The frost will melt and the defrost water will run
through the drain tube from the drip channel into an
evaporating vessel located at the bottom rear of the
refrigerator. (Fig 6) The defrost water will evaporate
automatically into the circulating air and the vessel will
not need emptying manually.
If we want to switch off the unit, turn the main switch
to "0", disconnect the refrigerator from the electricity
supply and leave the cabinet door open. After
defrosting the cabinet interior should be wiped out
with a clean, damp cloth.
Figure 6.
8. Reversing the door hang, (Fig. 7)
Lay the appliance on its back. Remove the 8
screws (1). Remove the door, together with the two
hinges (2), from the housing.
Remove the two cover caps (3) from the housing
and place them in the open hinge holes in the
housing. Place the bottom righthand hinge in the
top left of the door and the top righthand hinge in
the bottom left of the door and hang the door on its
hinges in the open cover cap holes in the housing.
Secure the hinges and cover caps with the 8
screws.
Check that the door closes easily and is sealed
properly.
Figure 7.
9. Replacing the decorative
door panel, (Fig. 8-10)
Remove the two screws (1) from the upper hinge of
the door.
Pull the door together with the hinge away from the
housing and up off the lower hinge bolt (2-3).
Remove screws (4) and pull off the frame edge (5).
Slide the decorative panel (6) out of the door frame
and insert the new panel (7), so that the upper
edge of the panel runs exactly parallel to the upper
edge of the frame. A new panel can be inserted
more easily into the upper edge of the frame when
the two corners are cut off by approx. 5 x 5mm (8).
Put the frame edge (5) back in place and secure
with screws.
Place the door on the lower hinge (9), slot the
upper hinge into the opening, press together with
the door against the housing and secure with the
two screws (11).
Figure 8.