miniCool DR 130 DR 140 Operating Instructions 207.5184.
Please read these operating instructions carefully before putting the refrigeration unit into operation. If you later sell or dispose of it, please ensure that the new owner receives these operating instructions. Thank you for choosing our appliance. We are sure it will provide you with trouble-free use.
CONTENT S 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. Unpacking View of the appliance Cleaning Positioning the appliance 4.1. Installation instruction Using the appliance 5.1. Temperature regulation Useful suggestions Defrosting, cleaning and maintenance Reversing the door hang Replacing the decorative door panel Changing the feet Assembly of door handle Customer service Putting into operation, technical data 13.1.
1. Unpacking After removal from the cardboard packaging, make sure the appliance is not damaged. If you find damage to the appliance resulting from transport, report it immediately to the transportation firm. 2. View of the appliance DR 140 DR 130 Figure 1. 1. Door lock 3. Thermostat knob 2. Sensor 4. Evaporator IN CASE IF YOUR REFRIGERATOR IS EQUIPPED WITH LOCK, ELECTROLUX LEISURE APPLIANCES DO NOT ACCEPT LIABILITY FOR LOSS OR DAMAGE OF KEYS.
3. Cleaning Clean the refrigerator thoroughly at intervals, as necessary. Remove the shelves; these, the cabinet interior and the door should be washed with a warm solution of sodium bi-carbonate. Finally wipe over with a cloth rinsed in warm water only, and dry with a clean cloth. Do not wash any plastic parts in water that is more than hand warm, and do not expose them to dry heat. The outside of the cabinet should be wiped down regularly with a clean, damp cloth.
5. Using the appliance To start the refrigerator connect the plug to the socket outlet and switch on the socket. The cooling fins should show signs of cooling after about 3 hours. The refrigerator needs about 6 hours at normal ambient temperature to reach 6 °C in the storage compartment. 5.1. Temperature regulation The usual setting required is in the region of 2 to 3 on the thermostat knob (Fig. 4), but this can vary with conditions of load and installation.
Slide the decorative panel (6) out of the door frame and insert the new panel (7), so that the upper edge of the panel runs exactly parallel to the upper edge of the frame. A new panel can be inserted more easily into the upper edge of the frame when the two corners are cut off by approx. 5 x 5mm (8). Put the frame edge (5) back in place and secure with screws.
13. Putting into operation Technical data: Model Type Gross volume Mains operation Input Energy consumption Climate class Refrigerant DR 130 MF 20-60 31 litre 220 - 240V (AC) 90W 0.99 kWh/24h N 245g NH3 +H2O DR 140 MF 20-60 41 litre 220 - 240V (AC) 90W 1.07 kWh/24h N 245g NH3 +H2O 13.1 Connecting to electrical mains The appliance may only be operated from nominal voltage mains as shown on the data plate. The appliance mains plug may be connected to a mains socket earthed in accordance with regulations.
14. Environmental protection information The appliance does not contain any CFCs. Ammonia (natural hydrogen and nitrogen compound) is used as a refrigerating agent in the refrigeration unit. The ozone-friendly cyclopentane is activated as a motive agent for the PU foam insulation. Sodium chromate is used for corrosion protection (less than 2 weight % of the coolant). 15. Recycling After unpacking the appliance, the packing materials should be delivered to a local collection site.
Printed by Xerox Hungary Ltd. 2004. 08. 26.