miniCool DS 200 DS 300 DS 400 DS 600 Freestanding and Built-in version Operating Instructions 207.5368.
Please read these operating instructions carefully before putting the refrigeration unit into operation. If you later sell or dispose of it, please ensure that the new owner receives these operating instructions. Please follow the installation details below carefully Guarantee is valid for products installed as described only. (See chapter 4.1) Thank you for choosing our appliance. We are sure it will provide you with trouble-free use.
CONTENT S 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. Unpacking View of the appliance Cleaning Positioning the appliance 4.1. Installation instruction 4.1.1. Built-in version 4.1.2. Freestanding version Using the appliance 5.1. Initial operation 5.2. Temperature regulation Useful suggestions Defrosting, cleaning and maintenance 7.1. Automatic defrost function Interior light Reversing the door hang Replacing the decorative door panel Customer service Putting into operation, technical data 12.1.
1. Unpacking After removal from the cardboard packaging, make sure the appliance is not damaged. If you find damage to the appliance resulting from transport, report it immediately to the transportation firm. All model are available in freestanding and built-in version. BI in the modelname refers for the built-in version and FS for the freestanding version. Please check your product version (figure 1.) and follow the relevant instructions about the installation and operation. Figure 1 2.
DS 400 DS 600 Figure 2. 1. Door lock (if available) 2. Door 3. Evaporator 4. Thermostat knob 5. Cooling unit room cover 6. Interior light 7. Shelves 8. Footframe 9. Sensor of Fuzzy Logic 10. Door racks IN CASE IF YOUR REFRIGERATOR IS EQUIPPED WITH LOCK, DOMETIC RT DO NOT ACCEPT LIABILITY FOR LOSS OR DAMAGE OF KEYS. A COMPLETE LOCK CAN BE SUPPLIED.
3. Cleaning Clean the refrigerator thoroughly at intervals, as necessary. Remove the shelves; these, the cabinet interior and the door should be washed with a warm solution of sodium bi-carbonate. Finally wipe over with a cloth rinsed in warm water only, and dry with a clean cloth. Do not wash any plastic parts in water that is more than hand warm, and do not expose them to dry heat. The outside of the cabinet should be wiped down regularly with a clean, damp cloth.
6. Useful suggestion Do not overfill the appliance. It is advisable to leave some space between the products in the cabinet to ensure efficient and even cooling. If the shelves are packed too tightly there may be unacceptable temperature variations. 7. Defrosting, cleaning and maintenance Figure 5. 4. Only the entire cooling unit must project into the duct as shown 5. Air passing through the duct must not be preheated by any source of heat 6.
9. Reversing the door hang, Fig. 9-10 Disconnect at the mains. Lay the appliance on its side. Loosen up 6 screws (1) of footframe and remove the footframe. Put the fridge on a desk to ease the work. Open the door and snap out the fixing tab (2) of the upper hinge pin by the help of screwdriver and push out the pin. (fig. 10.) Remove the door and the hinge washer. Remove the bottom hinge pin (3) and the upper and lower hinge plug (4) in the same way as in case of the upper hinge pin.
12. Putting into operation Technical data: Model Type Gross volume Mains operation Input Energy consumption Climate class Absorber Solution DS 200 DS20-60 22,5 litre 220 - 240V (AC) 65W 0.67 kWh/24h SN 147g H2O + 98 g NH3 DS 300 DS20-60 28,1 litre 220 - 240V (AC) 65W 0,72 kWh/24h SN 151g H2O + 101 g NH3 DS 400 DS20-60 36,7 litre 220 - 240V (AC) 65W 0.76 kWh/24h SN 151g H2O + 101 g NH3 DS 600 DS20-60 52,6 litre 220 - 240V (AC) 85W 0.89 kWh/24h SN 157g H2O + 105 g NH3 12.
13. Environmental protection information The appliance does not contain any CFCs/HCFCs. Ammonia (natural hydrogen and nitrogen compound) is used as a refrigerating agent in the refrigeration unit. The ozone-friendly cyclopentane is activated as a blowing agent for the PU foam insulation. Sodium chromate is used for corrosion protection (less than 2 % weight of the coolant). 14. Recycling After unpacking the appliance, the packing materials should be delivered to a local collection site.
Printed by Xerox Hungary Ltd. 2004. 02. 12.
