User manual

4. Only the entire cooling unit must project into the
duct as shown
5. Air passing thr
ough the duct must not be
preheated by any source of heat
6. Ventilation grills, if used, must have openings of
at leas
t 200cm
2
each
During installation, please ensure the mains plug is
accessible at all times.
5. Using the appliance
To start the refrigerator connect the plug to the socket
outlet and switch on the socket. The cooling fins should
show signs of cooling after about 1-2 hours depending on
ambiant temperature.
5.1. Initial operation
The device must be plugged into a properly earthed
socket.
The miniCool starts automatically with a self-test. The
LED illuminates after plugging-in several times and
after that continuous light can be seen if the door is
open.
The miniCool achieves its operating temperature after
several hours.
5.2. Temperature regulation
The usual setting required is in the region of the middle of
the thermostat knob (Fig. 6), but this can vary with
conditions of load and installation. If it is found necessary
to alter the setting,the knob can be turned to a higher
symbol to produce a colder temperature, or a lower
symbol to produce a warmer temperature. The effect of
any adjustment can be checked by means of a
thermometer after leaving the refrigerator operating for a
further period to settle down again.
Figure 6.
Figure 4.
miniCool
Air in
Air in
A
ir out
A
ir out
Ventilation grille
miniCool
A
B
6
GB
third of the refrigerator's door. Please make sure before final
fixing that the flat sliding part allows normal door opening in
order to avoid door sticking (figure 3).
4.1.2. Freestanding version
This version is supposed to use freestanding. Cooling unit
room cover protects from the hot parts of the cooling unit.
Foot frame with grilles ensures sufficient ventilation.
IMPORTANT
Please follow the installation details below carefully
Guarantee is valid for products installed as described
only.
1. The refrigerator must be le
vel both directions
2. There should be 20mm clear
ance to the wall
3. Ventilation must be provided as shown in
alternatives A, B, C or D (fig 4-5)
Figure 3.
Figure 5.
miniCool
min. 60 mm
Ventilation grille
Air in
miniCool
Air in
A
ir out
C
D
A
ir out