miniCool DS 200 DS 300 DS 400 DS 600 Type: DS20-60 Free-standing and Built-in versions Operating Instructions 207.5368.
Please read these operating instructions carefully before putting the refrigeration unit into operation. If you later sell or dispose of it, please ensure that the new owner receives these operating instructions. Please follow the installation details below carefully. Guarantee is valid for products installed as described only. (See chapter 4.1) Thank you for choosing our appliance. We are sure it will provide you with trouble-free use.
CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. Unpacking View of the appliance Cleaning Positioning the appliance 4.1. Installation instruction 4.1.1. Built-in versions 4.1.2. Free-standing versions Using the appliance 5.1. Initial operation 5.2. Temperature regulation 5.3. Cooling unit control (CUC) Useful suggestions Defrosting, cleaning and maintenance 7.1.
1. Unpacking After removal from the cardboard packaging, make sure the appliance is not damaged. If you find damage to the appliance resulting from transport, report it immediately to the transportation firm. All model are available in freestanding and built-in version. BI in the modelname refers for the built-in version and FS for the freestanding version. Please check your product version (figure 1.) and follow the relevant instructions about the installation and operation.
11 11 DS 400 DS 600 Figure 2. 1. 2. 3. 4. 5. 6. Door lock (if available) Door Evaporator Thermostat knob Cooling unit cover Interior light 7. 8. 9. 10. 11. Shelves Footframe Air-sensor Door racks Evaporator-sensor IN CASE IF YOUR REFRIGERATOR IS EQUIPPED WITH LOCK, DOMETIC ZRT DO NOT ACCEPT LIABILITY FOR LOSS OR DAMAGE OF KEYS. HOWEVER A COMPLETE LOCK CAN BE SUPPLIED. 3. Cleaning Clean the refrigerator thoroughly at intervals, as necessary.
4. Positioning the appliance When first using this refrigerator please consider the following points: ENSURE REFRIGERATOR IS LEVEL THE PIPEWORK AT THE BACK GETS HOT IN USE THE REFRIGERATOR HAS NO 'MOTOR' AND IS THEREFORE VIRTUALLY SILENT ALLOW AT LEAST 3 HRS. FOR SIGNS OF COOLING During the refrigeration process, the appliance gives off heat from the condenser (under the upper part of the rear cover) into the surrounding air.
6. Ventilation grills, if used, must have an free openings of at least 200 cm² each During installation, please ensure the mains plug is accessible at all times. 5. Using the appliance To start the refrigerator connect the plug to the socket outlet and switch on the socket. The cooling fins should show signs of cooling after about 1-2 hours depending on ambient temperature. 5.1. Initial operation The device must be plugged into a properly earthed socket. The miniCool starts automatically with a self-test.
Open the door and snap out the fixing tab (2) of the upper hinge pin by the help of screwdriver and push out the pin. (fig. 10.) Remove the door and the hinge washer. Remove the bottom hinge pin (3) and the upper and lower hinge plug (4) in the same way as in case of the upper hinge pin. Snap in the lower hinge pin (3) to the desired side. Put back the door and the hinge washer and snap in the upper hinge pin (2). Snap in the 2 hinge plugs (4) too. Put the foot frame back and fit it with the 7 screws. 10.
12. Putting into operation Technical data: Model Type Gross volume Mains operation Input Energy consumption Climate class Absorber Solution DS 200 DS20-60 22,5 litres 220 V (AC) 65W 0.74 kWh/24h N/T 147g H2O + 98 g NH3 DS 300 DS20-60 28,1 litres 220 V (AC) 65W 0,76 kWh/24h N/T 151g H2O + 101 g NH3 12.1. Connecting to electrical mains The appliance may only be operated from nominal voltage mains as shown on the data plate.
Printed by Océ Hungária Kft. Rev.: 2006. 09. 14.
