LEGEND Type: DS20-60 Operating Instructions 207.5368.
Please read these operating instructions carefully before putting the refrigeration unit into operation. If you later sell or dispose of it, please ensure that the new owner receives these operating instructions. Please follow the installation details below carefully. Guarantee is valid for products installed as described only. (See chapter 4.1) Thank you for choosing our appliance. We are sure it will provide you with trouble-free use.
CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. Unpacking View of the appliance Cleaning Positioning the appliance Using the appliance 5.1. Initial operation 5.2. Temperature regulation 5.3. Cooling unit control (CUC) Useful suggestions Defrosting, cleaning and maintenance 7.1. Automatic defrost function Interior light Customer service Putting into operation, technical data 10.1.
1. Unpacking After removal from the cardboard packaging, make sure the appliance is not damaged. If you find damage to the appliance resulting from transport, report it immediately to the transportation firm. 2. View of the appliance 11 DS 600 Figure 2. 1. 2. 3. 4. 5. 6. Door lock (if available) Door Evaporator Thermostat knob Cooling unit cover Interior light 7. 8. 9. 10. 11.
3. Cleaning Clean the refrigerator thoroughly at intervals, as necessary. Remove the shelves; these parts, as well as the cabinet interior and the door should be washed with a warm solution of sodium bi-carbonate. Finally wipe over with a cloth rinsed in warm water only, and dry with a clean cloth. Do not wash any plastic parts in water that is more than hand warm, and do not expose them to dry heat. The outside of the cabinet should be wiped down regularly with a clean, damp cloth.
10.1. Connecting to electrical mains Figure 7. 7.1. Automatic defrost function The first defrosting phase commences 39 hours after the start and lasts for two hours. After this, the device operates for 22 hours at a time, followed by a defrosting period of 2 hours. 8. Interior light Two light-emitting diodes (A) on an electronic PCB illuminate the cooling compartment when the door is opened. Two sensors (B) control whether the door is open or not and the LEDs will work accordingly.
The ozone-friendly cyclopentane is activated as a blowing agent for the PU foam insulation. Sodium chromate is used for corrosion protection (less than 2 % weight of the coolant). 12. Recycling After unpacking the appliance, the packing materials should be delivered to a local collection site. At the end of its useful lifetime, the appliance should be delivered to a specialized collection and reprocessing firm, which reclaims the usable materials. The rest is properly destroyed.
Printed by Océ Hungária Kft. Rev.: 2007. 04. 06.