User manual

Dirty filters and clogged spray arm de-
crease the washing results.
Make a check regularly and, if neces-
sary, clean them.
Cleaning the filters
B
A
1. Turn the filter (A) counterclock-
wise and remove it.
2.
Remove the filter (B).
3. Wash the filters with water.
4. Before you put the filter (B)
back, make sure that there are
no residues of food or soil in or
around the edge of the sump.
5.
Put the filter (A) into position in
filter (B). Turn it clockwise until it
locks.
An incorrect position of the fil-
ters can cause bad washing re-
sults and damage to the appli-
ance.
Cleaning the spray arm
1. Turn the nut counterclockwise.
2.
Remove the spray arm.
3.
Clean the holes.
If the holes in the spray arm are clogged,
remove remaining parts of soil with a thin
pointed object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads
or solvents.
TROUBLESHOOTING
The appliance does not start or it stops
during operation.
Before you contact the Service, refer to the
information that follows for a solution to the
problem.
With some problems, the display
shows an alarm code:
•
- The appliance does not fill with wa-
ter.
•
- The appliance does not drain the
water.
•
- The anti-flood device is on.
Warning! Deactivate the appliance
before you do the checks.
Problem Possible solution
You cannot activate the appliance. Make sure that the mains plug is connected to the
mains socket.
Make sure that there is not a damaged fuse in the fuse
box.
11