User manual

- 12 -
Service
Service and spare parts
Servicing and repairs must be carried out by a service
company authorised by the supplier. Use only spare
parts supplied by these.
Before calling service, use the trouble shooting table
”In the event of a fault” to try to attend to the fault yourself.
Note that electrical faults shall always be rectified by a
certified electrician.
State the appliance’s model designation, product- and
serial numbers according to the data plate affixed to the
rear of the dishwasher.
You can record these details here:
TYPE.
............................................................
MOD. ............................................................
PROD.NO. ............................................................
SER.NO. ............................................................
Purchase date............................................................
Under what circumstances does the fault occur?
Never attempt to repair the dishwasher yourself.
Repairs carried out by unauthorised or inexperienced
persons can cause injury or serious malfunctioning.
This appliance complies with the following E.E.C. directives:
– 73/23/EEC, dated 19.02.1973 – low-voltage directive.
– 89/336/EEC, dated 03.05.1989 (incl. amendment
– 92/31/EEC) – directive on electromagnetic compatibility.
Indicator for the selected programme
flashes:
The display shows error code , 10.
(Problems with the water supply).
• Is the water tap turned on?
• Is the filter inside the inlet hose blocked?
• Is the water inlet hose kinked or squashed?
• Are the filters clogged?
Fault Check
Indicator for the selected programme
flashes:
The display shows error code , 20.
(Problems with water drainage).
• Is the spigot blocked?
• Is the water drain hose kinked or nipped?
• Are the filters clogged?
In the event of a fault
With help of the error code on the display, it’s possible that you can solve the problem yourself. When the problem is
s
olved, press in the button for the disrupted programme and the programme continues.
For other error codes on the display ( , followed by a numbers):
• Interrupt the dishwashing cycle.
• Switch the dishwasher off.
• Select the relevant programme again.
If the problem occurs again, contact your local service centre, stating the error code.