Operation Manual

Pull the door together with the hinge away from the housing and up off

the lower hinge bolt (2-3).

Remove screws (4) and pull off the frame edge (5).

Slide the decorative panel (6) out of the door frame and insert the new

panel (7), so that the upper edge of the panel runs exactly parallel to

the upper edge of the frame. A new panel can be inserted more easily

into the upper edge of the frame when the two corners are cut off by

approx. 5 x 5mm (8). Put the frame edge (5) back in place and secure

with screws.

Place the door on the lower hinge (9), slot the upper hinge into the

opening, press together with the door against the housing and secure

with the two screws (11).

12. Changing the feet (Fig. 10)

Should you wish to install your miniCool, you will not need the 40-mm

feet. After having removed the 40-mm feet, you can then re-attach the

12-mm feet, located inside the 40-mm feet, to the front and rear fixing

points. The 40-mm feet and the 4 remaining screws should be

retained for future use.

13. Assembly of door handle (Fig. 11)

14. Customer service

Before you call a service engineer, carry out the following simple

tests:

Is there a power failure? Check the fuses.

Is the plug firmly connected to the socket and is the socket

switched on? Check the socket by plugging in another appliance,

e.g. a table lamp.

Is the thermostat at the correct setting? (normally 3 or 4).

Has the door not been closed properly causing the inside

temperature to rise too quickly?

Is the refrigerator level?

Has the ventilation become obstructed?

If after checking all the above points, the refrigerator is still not working

satisfactorily, contact your nearest service engineer. State the

problem, model, product- and serial-number.

(Details of the model, product- and serialnumber are to be found on

the data label in the top left of the inside compartment.)

This refrigerator is equipped with overheating protection. An

authorised service technician can check whether this has been

triggered or not.

In the event of a fault developing, contact your nearest Service

Centre-see local telephone directory.

Figure 9.

Figure 10.

Figure 11.

Figure 8.