miniCool EA 3100 EA 0300 EA 0301 EA 0302 EA 3080 RA 80 EA 3120 EA 3140 RA 140 Type: MF20-60 OoFT No: N19548 207.5184.
Please read these operating instructions carefully before putting the refrigeration unit into operation. If you later sell or dispose of it, please ensure that the new owner receives these operating instructions. Please follow the installation details below carefully Guarantee is valid for products installed as described only. (See chapter 4.1) Thank you for choosing our appliance. We are sure it will provide you with trouble-free use.
C ONTENT S 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. Unpacking View of the appliance Cleaning Positioning the appliance 4.1. Installation instruction Using the appliance 5.1. Temperature regulation 5.2. Cooling unit control (CUC) Ice cubes Useful suggestions Defrosting, cleaning and maintenance 8.1.
1. Unpacking After removal from the cardboard packaging, make sure the appliance is not damaged. If you find damage to the appliance resulting from transport, report it immediately to the transportation firm. 2. View of the appliance EA 3100 EA 3080 EA 3120 EA 3140 Figure 1. 1. Door lock 5. Lamp (if available) 2. Sensor 6. Fixing foot (if available) 3. Thermostat knob 7. Evaporator sensor (behind evaporator) 4. Evaporator Attention! Since Ser. No.
3. Cleaning Clean the refrigerator thoroughly at intervals, as necessary. Remove the shelves; these, the cabinet interior and the door should be washed with a warm solution of sodium bi-carbonate. Finally wipe over with a cloth rinsed in warm water only, and dry with a clean cloth. Do not wash any plastic parts in water that is more than hand warm, and do not expose them to dry heat. The outside of the cabinet should be wiped down regularly with a clean, damp cloth.
During installation, please ensure the mains plug is accessible at all times. 5. Using the appliance To start the refrigerator connect the plug into a properly earthed socket. The cooling fins should show signs of cooling after about 3 hours. The refrigerator needs about 6 hours at normal ambient temperature to reach 6 °C in the storage compartment. 5.1. Temperature regulation The usual setting required is in the region of 2 to 3 on the thermostat knob (Fig.
10. Reversing the door hang (Fig. 6-7) Lay the appliance on its back. Remove the 8 screws (1). Remove the door, together with the two hinges (2), from the housing. Remove the two cover caps (3) from the housing and place them in the open hinge holes in the housing. Place the bottom righthand hinge in the top left of the door and the top righthand hinge in the bottom left of the door and hang the door on its hinges in the open cover cap holes in the housing.
13. Assembly of door handle (Fig. 12) Figure 12. 14. Customer service Before you call a service engineer, carry out the following simple tests: Problem Possible cause The appliance does not Thermostat control is set too low cool sufficiently Too much food to be cooled was put in Door is not shut properly. Refrigerator not level Internal air circulation is restricted. External air circulation is restricted.
15. Putting into operation Technical data: Model Type Gross volume Mains operation Input Energy consumption Climate class Refrigerant EA 3100, EA 0300, EA 0301, EA 0302 MF20-60 31 litre 240V (AC) 90W 0.97 kWh/24h N 159g H2O+86g NH3 EA 3080 RA 80 MF20-60 23 litre 240V (AC) 90W 0,92 kWh/24h N 159g H2O+86g NH3 EA 3120 EA 3140 RA 140 MF20-60 MF20-60 31 litre 41 litre 240V (AC) 240V (AC) 90W 90W 0.99 kWh/24h 1.07 kWh/24h N N 159g H2O+86g NH3 159g H2O+86g NH3 15.1.
Printed by Océ Hungária Kft. Rev.: 2008. 01. 28.