User manual

CAUTION:
Do not keep any easily combustible substances such as ether, petrol,
adhesive, propane gas etc. in the refrigerator as this could cause an
explosion!
ICE CUBES
Fill the ice tray to 4/5 with fresh drinking water, cover with the lid and place the
closed ice tray on the ice-tray shelf. Wipe off any excess water to prevent the ice
tray from freezing to the surface.
To speed up the making of ice cubes, turn the thermostat to position 5 for a short
while. Remember to turn the dial to its normal setting when the ice cubes are
frozen.
To remove the cubes from the ice tray, hold it under running water. Remove the
lid with the ice cubes from the ice tray and the ice cubes can now be taken out
easily.
CARE AND MAINTENANCE
DEFROSTING
Frost will gradually form on the cooling surfaces and it must not be allowed to
become too thick since it impairs the cooling efficiency of the refrigerator.
Check the formation of frost regularly and defrost the refrigerator if the layer of
frost is thicker than 6 mm.
The applicance is fitted a fully automatic defrosting system.
AUTOMATIC DEFROSTING
This frost-formation is kept back by the FUZZY LOGIC system bult into the
appliance by switching off the unit for two hours in every 24 hours.
12