User manual

13
DEFROST WATER
During the defrosting process the water rums through a hose into a container on
the back of the refrigerator where it evaporates.
This container does not need to be emptied.
CLEANING
Cleand the inside of your refrigerator regularly to keep it fresh and hygienic.
Switch off the appliance and pull out the plug. Clean the interior and fittings
carefully with a mild detergent in lukewarm water.
Never use acidic, abrasive or strong-smelling detergents or wax polishes as
these will damage the surfaces and leave an unpleasant smell.
The outside should occasionally be dusted or wiped over with a damp cloth. The
door seal should only be cleaned with water and rubbed down with talcum
powder from time to time.
If possible, the unit should also be dusted occasionally with a brush or a vacuum
cleaner. Ensure that the plug is disconnected when doing this.
LONGER PERIODS OF ABSENCE
If you wish to switch off the appliance for a longer period of time, pull out the
plug, defrost the refrigerator and clean it carefully. Leave the door open to
prevent unpleasant odours from forming.
RESERVING THE DOOR HANG (fig. 2)
Lay the appliance on its back. Remove the 8 screws (1). Remove the door,
together with the two hinges (2), from the housing.
Remove the two cover caps (3) from the housing and place them in the open
hinge holes in the housing. Place the bottom righthand hinge in the top left of
the door and the top righthand hinge in the bottom left of the door and hang the
door on its hinges in the open cover cap holes in the housing. Secure the hinges
and cover caps with the 8 screws.
Check that the door closes easily and is sealed properly.
REPLACING THE DECORATIVE DOOR PANEL (fig. 3-5)
Remove the two screws (1) from the upper hinge of the door.