User manual

7
2. INSTALLATION
LOCATION C (fig. 6)
Check that the outgoing electrical connections from
the terminal strip are tight.
3.
Refit side cover of the compressor compartment into
position refixing the screws holding the side cover
(fig. 7)
4.
INSTALL firmly the appliance on a level floor,
preferably on wooden blocks or on a wooden platform
to protect it from damp and dirt. (fig. 8)
Leave sufficient space on all sides of the
appliance, keep it away from the walls
for good circulation of air around it, see
below:
Back and left side should be minimum 3
cm away from the walls (fig. 8a)
Hinges can be pushed against the wall.
Right side should be minimum 10 cm
away from the wall (fig. 8b)
5.
The appliance has 4 supporting legs. If
the appliance is not in a level and stable
position, adjust this by adding wooden
blocks or similar under the legs.
Fig 6.
Fig 7.
Fig 8.
Fig 8b.
Fig 8a.