Operation Manual

Operating the roof air conditioner FreshJet

If data transmission failed, point the remote control to the IR receiver on the control

panel and press the SET button. This transmits the data to the roof air conditioner.

The roof air conditioner confirms the receipt of data with a high note.

Switching only the remote control to or from stand-by

In stand-by mode, the remote control display shows only the time.

If the remote control is not pointing to the IR receiver (fig. 2

4, page 3) on the

control panel, you can activate the remote control or switch it to stand-by

independently from the roof air conditioner:

➤ Press the button.

9.3 Hint for improved use

The following hints will optimise the performance of your roof air conditioner:

• Improve the heat insulation of your vehicle by sealing gaps and hanging reflective

blinds or curtains on your windows.

• If the vehicle has been subjected to direct sunlight for a long time: Operate the

roof air conditioner in the “Circulating air” ( ) mode with the windows open for

a while before switching on the “Cooling” ( ) air conditioning mode.

• Avoid opening doors and windows as far as possible in the “Cooling” ( )

mode.

• Align the air nozzles sensibly.

• Make sure the air nozzles and intake grille are not covered by cloths, paper or

other objects.

9.4 Switching the roof air conditioner on and off

NOTE

When it is switched on, it begins to condition the air to the values that

were set most recently.

FreshJet-ADB2015-O-16s.book Seite 28 Donnerstag, 1. Februar 2018 12:02 12