Operation Manual

EN
FreshJet Operating the roof air conditioner
31
9.8 Adjusting the air nozzles
The air supply within the vehicle can be regulated by setting the air nozzles (fig. 4,
page 5).
➤ Chillout ADB: Turn the slats (1) in the air nozzles in the required direction using
the thumb wheel (2).
➤ ADB: Turn the slats (1) in the air nozzles independently in the required directions
using the thumb wheels (2, 3, 4). The air flow can be adjusted to the right and
left, as well as to the ceiling or the floor.
Move the central slide (3) to direct the air flow to the front or back.
9.9 Setting the timer
The timer function allows you to set a specific time period for air conditioning. You
can specify the switch-on time, the switch-off time or both values.
I
➤ Before programming the timer, select the air conditioning mode and all required
values (e.g. temperature).
Setting the switch-on time
➤ Press the button once.
✓ The ON symbol ( ) flashes on the display of the remote control.
➤ Use the + or – button to set the time when the roof air conditioner is to switch on.
➤ Press the SET button to transmit the value to the roof air conditioner.
✓ The switch-on time is set on the roof air conditioner.
The roof air conditioner is switched on with the selected air conditioning mode
at the specified time.
➤ Switch the roof air conditioner to stand-by.
Setting the switch-off time
➤ Press the button twice.
✓ The OFF symbol ( ) flashes on the display of the remote control.
➤ Use the + or – button to set the time when the roof air conditioner is to switch off.
NOTE
The remote control returns to its initial mode if no button is pressed on
the remote control for 15 seconds while programming the timer.
FreshJet-ADB2015-O-16s.book Seite 31 Donnerstag, 1. Februar 2018 12:02 12