Operation Manual

EN
FreshJet Operating the roof air conditioner
33
➤ Press the button.
✓ The symbol appears in the display.
The sleep function is activated.
➤ To deactivate the sleep function press the button again.
I
9.11 Activating the “I feel” function
When this function is active, the remote control measures the room temperature and
transmits this measurement to the roof air conditioner every 10 minutes. The roof air
conditioner adapts the target value to this measurement. The “I feel” function is only
active when the temperature range is between +18 °C and +29 °C.
➤ Press the button.
✓ The symbol appears in the display.
The “I feel” function is activated.
➤ Position the remote control so that it points at the IR receiver (fig. 2
4, page 3)
on the control panel. Otherwise, the values cannot be transmitted to the roof air
conditioner.
I
When the temperature rises above +29 °C or falls below +18 °C, the “I feel” function
is deactivated.
✓ The symbol flashes three times in the display and then turns off.
9.12 Operating the lights (depending on the models)
The lights on the roof air conditioner can be dimmed. When switched on, they revert
to the most recently specified brightness.
I
NOTE
The sleep function is deactivated if the MODE button is pressed.
NOTE
The remote control should not be kept in a part of the room that is
considerably warmer or colder than the average room temperature.
It may not, for example, be left in the sun or in front of the roof air
conditioner.
NOTE
The button on the remote control is activate even if the remote
control is turned off.
FreshJet-ADB2015-O-16s.book Seite 33 Donnerstag, 1. Februar 2018 12:02 12