Harrier-Lite_INM.book Seite 1 Donnerstag, 30.
Harrier-Lite_INM.book Seite 2 Donnerstag, 30. April 2020 3:45 15 © 2020 Dometic Group. The visual appearance of the contents of this manual is protected by copyright and design law. The underlying technical design and the products contained herein may be protected by design, patent or be patent pending. The trademarks mentioned in this manual belong to Dometic Sweden AB. All rights are reserved.
Harrier-Lite_INM.book Seite 3 Donnerstag, 30. April 2020 3:45 15 Harrier series Explanation of symbols Original instructions Please read this instruction manual carefully before installation and start-up, and store it in a safe place. If you pass on the device to another person, hand over this instruction manual along with it. Table of contents 1 D ! ! A I EN 1 Explanation of symbols . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 2 Safety and installation instructions . . .
Harrier-Lite_INM.book Seite 4 Donnerstag, 30. April 2020 3:45 15 Safety and installation instructions 2 Harrier series Safety and installation instructions Please observe the prescribed safety instructions and stipulations from the vehicle manufacturer and service workshops.
Harrier-Lite_INM.book Seite 5 Donnerstag, 30. April 2020 3:45 15 Harrier series Target group for this instruction manual • Do not make any alterations or conversions to the device. • Never drive through automatic car washes when the roof air conditioner is mounted. • If faults occur in the refrigerant circuit, the system must be checked by a specialist company and repaired properly. The refrigerant must never be released into the air.
Harrier-Lite_INM.book Seite 6 Donnerstag, 30. April 2020 3:45 15 Scope of delivery 4 Harrier series Scope of delivery 1 1 2 5 7 3 8 4 6 No. in fig. 1 5 Quantity Description 1 1 Roof air conditioner 2 1 Roof plate 3 1 Air distribution box (ADB) 4 1 ADB centre cover 5 5 Duct sections 6 3 Cable connectors 7 4 Fastening bolts 8 1 Remote control Accessories Available as accessories (not included in the scope of delivery): 6 Description Ref. no.
Harrier-Lite_INM.book Seite 7 Donnerstag, 30. April 2020 3:45 15 Harrier series 6 Intended use Intended use The Harrier series air conditioner are designed for installation on the roof of a caravan or recreational vehicle to provide reverse cycle heating and cooling. The device is intended for vehicles with roofs that are from 30 to 100 mm thick. The device must be installed so that it is within ±10° of the horizontal plane. It is not suitable for houses and apartments.
Harrier-Lite_INM.book Seite 8 Donnerstag, 30. April 2020 3:45 15 Installation 8 Harrier series Installation ! 8.1 CAUTION! Beware of injury The roof air conditioner may only be installed by qualified personnel. The following information is intended for technicians who are familiar with the guidelines and safety precautions to be applied. Note on installation Read this installation manual completely before installing the roof air conditioner.
Harrier-Lite_INM.book Seite 9 Donnerstag, 30. April 2020 3:45 15 Harrier series 8.1.1 Installation Note on transport 4 A B C • Pay attention to the orientation of the up arrows on the carton. Do not install the unit if it has been upside down for any period of time (fig. 4 A). • Always have someone help you carry the roof air conditioner. • Always lift the roof air conditioner to move it and never drag it over the roof (fig. 4 B). • Do not use the ventilation slots to lift it (fig. 4 C). 8.1.
Harrier-Lite_INM.book Seite 10 Donnerstag, 30. April 2020 3:45 15 Installation Harrier series • Make sure no combustible objects are stored or installed near the air outlet. A distance of at least 50 cm should be kept. • Make sure that there are no objects within the vehicle which could obstruct the attachment of the air outlet unit or the cooled air from flowing through the swivelling air distribution nozzles.
Harrier-Lite_INM.book Seite 11 Donnerstag, 30. April 2020 3:45 15 Harrier series 8.2 Installation Making a new opening 5 A B 40 0m 36 0m m m 00 m m 0m m 4 36 Harrier Lite 997 360 587 85 400 94 360 114 105 = = 48 50 665 = 48 567 30 – 100 400 240 30 518 579 Harrier Plus 1070 750 400 625 65 360 645 85 400 94 105 360 114 280 30 – 100 45 = 518 579 See fig. 5 ➤ Select an area at the centre on the roof between two longitudinal supports.
Harrier-Lite_INM.book Seite 12 Donnerstag, 30. April 2020 3:45 15 Installation Harrier series 6 A B See fig. 6 ➤ Drill out the corners (A). ➤ Carefully cut out the opening on the roof using a keyhole saw or a similar tool (B). ➤ Make sure no electrical power cables are damaged. 7 A B 2. 1. See fig. 7 ➤ Before installation, check whether the roof hole needs reinforcing. ➤ If needed, remove the foam according to the width of your reinforcing rails (not in scope of delivery) (A).
Harrier-Lite_INM.book Seite 13 Donnerstag, 30. April 2020 3:45 15 Harrier series 8.3 I Installation Installing in an existing opening NOTE • Existing roof hatch openings in accordance with fig. 8 are suitable for installing the roof air conditioner. • Dispose of all waste material, glue, silicone and seals separately. Observe the disposal guidelines. • The manufacturer only assumes liability for parts included in the scope of delivery.
Harrier-Lite_INM.book Seite 14 Donnerstag, 30. April 2020 3:45 15 Installation Harrier series 0 See fig. 0 A 8.4 D NOTICE! Observe the sealant manufacturer’s instructions. ➤ Seal the screw holes and recesses with a flexible non-hardening butyl sealing compound (e.g. SikaLastomer-710, Selleys Butyl Mastic, Bostik ezycaulk butyl sealant, or similar products).
Harrier-Lite_INM.book Seite 15 Donnerstag, 30. April 2020 3:45 15 Harrier series Installation a See fig. a ➤ Make an opening on one side in order to feed through the electrical power supply cable. ➤ Feed the 240 Vw cable through the opening into the vehicle interior. 8.5 A Installing the roof air conditioner ADB NOTICE! Risk of damage Observe the structural strength of the roof of the vehicle. The roof of the vehicle must be able to bear the weight of the roof air conditioner.
Harrier-Lite_INM.book Seite 16 Donnerstag, 30. April 2020 3:45 15 Installation Harrier series c See fig. c ➤ Lift the roof air conditioner onto the roof of the vehicle. ➤ Position the roof air conditioner onto the roof plate and align into the groove in the base pan. Observe the direction of travel.
Harrier-Lite_INM.book Seite 17 Donnerstag, 30. April 2020 3:45 15 Harrier series 8.5.1 Installation Attaching the roof air conditioner d See fig. d ➤ Use the corners of the front of the base pan to help align the unit with the roof plate.
Harrier-Lite_INM.book Seite 18 Donnerstag, 30. April 2020 3:45 15 Installation 8.5.
Harrier-Lite_INM.book Seite 19 Donnerstag, 30. April 2020 3:45 15 Harrier series Installation f 3 2 1. 2. 1 3. See fig. f 8.5.3 Mains cable ➤ Connect the roof air conditioner with the mains voltage supply. Connect the cables (1) to a cable connector (2).
Harrier-Lite_INM.book Seite 20 Donnerstag, 30. April 2020 3:45 15 Installation 8.5.4 Harrier series Communication cable ➤ Pull out the filter slightly to create a gap for the communication cable (3). ➤ Feed the communication cable through the gap and locate the wire in the opening. g See fig. g ➤ Stack the duct sections and place against the roof thickness: the duct height should match the roof height.
Harrier-Lite_INM.book Seite 21 Donnerstag, 30. April 2020 3:45 15 Harrier series Installation ➤ Fasten the ADB to the ceiling through to the roof air conditioner with the 4 bolts supplied. h A 2.5±0.3 Nm See fig. h A 8.5.5 NOTICE! Risk of damage Tighten to the specified torque. Do not overtighten! ➤ Tighten the screws using a torque spanner and a fastening torque of 2.5 Nm ±0.3 Nm. Communication cable ➤ Connect the communication 4 pin plug into the socket on the side of the display (2) in the ADB.
Harrier-Lite_INM.book Seite 22 Donnerstag, 30. April 2020 3:45 15 Installation Harrier series i click click See fig. i ➤ Clip the centre cover to the ADB. The installation is now completed. Connect to the power and test.
Harrier-Lite_INM.book Seite 23 Donnerstag, 30. April 2020 3:45 15 Harrier series 9 Technical data Technical data Contains fluorinated greenhouse gases. Hermetically sealed equipment. Harrier Lite HL36H401RI, HL36H401RIY Compressor cooling capacity: Harrier Plus HP36H401RI, HP36H401RIY 3600 W Cooling capacity based on ISO 5151: 2413 W 3028 W Heating capacity based on ISO 5151: 2421 W 3017 W Rated input voltage: 220 Vw to 240 Vw/ 50 Hz Rated current cooling: 7.5 A 6.
YOUR LOCAL SUPPORT YOUR LOCAL SALES OFFICE dometic.com/dealer dometic.com/contact dometicĶ ,*ű0 )"0Ŗ,= "s 4445102831 YOUR LOCAL DEALER 4450018156 dometic.com 554-584-MA02 04/2020 Harrier-Lite_INM.book Seite 24 Donnerstag, 30.
