User manual

- 7 -
ICE MAKER
Before the ice maker can operate, make sure that:
The refrigerator is connected to 120 V AC .
The water valve supplying the refrigerator is turned on.
The ice level bail arm is in its fully down position.
How it works
When the ice maker thermostat senses the preset temperature
for the ejection of the ice cubes, the fi ngers will start to rotate,
dumping any ice cubes and fi lling the mold with water. When
the storage container is full, the bail arm will come in contact
with the ice cubes. The bail arm cannot return to the full down
position and the ice production is stopped until the bin is emp-
tied, or ice cubes are removed.
To prevent water from splashing out of the mold assembly
when your recreational vehicle is moving, raise the bail arm to
the full “UP/OFF” position about 1-1/2 hours before departing.
This will allow the water in the mold to freeze.
Water supply
The water supply system must have a minimum pressure of 15
pounds per square inch gauge (psig). A 1/4” diameter water line
to the water valve should be used at the rear of the refrigerator.
The water line must have a manual shutoff valve placed where
it is easily accessible.
The maximum water level is represented by a thin line. It is
essential that the water level does not exceed this line!
If necessary change the water fl ow by adjusting the water sup-
ply, see the step-by-step instruction in
ADJUSTING THE SIZE
OF CUBES.
•
•
•
Ice level
bail arm
Dow
n
positio
n
OPERATING INSTRUCTIONS
Cover
Adjusting
screw
Adjusting the size of cubes
NOTE!
If the ice maker was cleaned and drained, no ice cubes
will be dumped into the bin during the fi rst cycle.
The fi rst few cycles may have small cubes due to air trapped
in the water lines. The fi rst container of ice cubes should be
dumped if the water system has been winterized or not used
for several weeks. Once the ice maker has run through several
cycles and if cubes are to small or sticking together, adjustment
is necessary on the amount of water entering the mold.
To adjust the size of cubes, follow these steps:
Remove the protective cover from the ice maker
mechanism.
Locate the adjusting screw under the protective
cover. Turn the screw counterclockwise to increase
the size of cubes.
Turn the screw clockwise to decrease the cube size
or if the mold is overfi lling, and the cubes are stuck
together.
NOTE!
To prevent overfi lling, DO NOT turn the adjustment
screw more than one revolution at a time. Allow the ice maker
to cycle several times before another adjustment is made. Be
sure to replace the protective cover on the cycle after the adjust-
ments are complete.
1.
2.
3.
Maximum
water level