User manual

- 7 -
STORAGE PROCEDURE/WINTERIZING THE
REFRIGERATOR
The refrigerator is equipped with a heater tape wrapped around
the water solenoid valve and outlet water tube. During cold
weather operation below 32°F/0°C the automatic temperature
switch will turn the heater tape on automatically.
If the RV will not be in use for an extended period of time or
put into storage:
Drain the RV water system.
Disconnect the water lines from the inlet and outlet sides
of the water valve. Drain the lines into a cup and allow the
lines to dry.
The ice maker should be drained and dried, see
DRAINING
THE ICE MAKER
.
Using a lukewarm soda solution, clean the interior liner of
the refrigerator. Clean the fi nned evaporator, ice trays and
shelves. Use warm water only and never strong chemicals or
abrasives since these can damage the protective surfaces.
Leave the doors ajar.
•
•
•
•
•
Adjusting the size of cubes
NOTE!
If the ice maker was cleaned and drained, no ice cubes
will be dumped into the bin during the fi rst cycle.
The fi rst few cycles may have small cubes due to air trapped
in the water lines. The fi rst container of ice cubes should be
dumped if the water system has been winterized or not used
for several weeks. Once the ice maker has run through several
cycles and if cubes are to small or sticking together, adjustment
is necessary on the amount of water entering the mold.
To adjust the size of cubes, follow these steps:
Remove the protective cover from the ice maker
mechanism.
Locate the adjusting screw under the protective
cover. Turn the screw counterclockwise to increase
the size of cubes.
Turn the screw clockwise to decrease the cube size
or if the mold is overfi lling, and the cubes are stuck
together.
NOTE!
To prevent overfi lling, DO NOT turn the adjustment
screw more than one revolution at a time. Allow the ice maker
to cycle several times before another adjustment is made. Be
sure to replace the protective cover on the cycle after the adjust-
ments are complete.
1.
2.
3.
OPERATING INSTRUCTIONS
Cover
Adjusting
screw
CAUTION
!
Do not use:
A knife or an ice pick, or other sharp tools to re-
move frost from the freezer shelves. It can create a
leak in the ammonia system.
A hot air blower. Permanent damage could result
from warping the metal or plastic parts.
•
•