User manual

– 4 –
NDA1402
When installing the refrigerator, make sure to separate the
combustion system from the living space of the mobile home
or recreational vehicle. An opening toward the outside at fl oor
level in the refrigerator compartment must be provided for
ventilation of heavier-than-air fuel gases.
VENTILATION HEIGHTS
It is essential that all maximum or minimum dimensions are
strictly maintained as the performance of the refrigerator is de-
pendent on adequate fl ow of air over the rear of the refrigerator.
For an installation with roof vent and lower side vent, the mini-
mum ventilation height should be
69-1/8 inches (1756 mm)
.
VENTILATION REQUIREMENTS
GENERAL INFORMATION
Provide necessary air circulation over the cooling unit. Open-
ings for air supply or for venting of combustion products shall
have a minimum dimension of not less than 1/4 inch.
Certifi ed installations require one roof vent and one lower side
vent. Proper installation requires one lower fresh air intake
and one upper exhaust vent. The ventilation kits shown in this
manual have been certifi ed for use with NEA1402 and
NDA1402. The ventilation kits must be installed and used
without modifi cation.
The lower vent of the recommended kits is provided with
proper size openings. The fl ow of combustion and ventilating
air must not be obstructed. The lower side vent is fi tted with
a panel, which provides an adequate access opening for ready
serviceability of the burner and control manifold of the refrig-
erator. This should be centered on the back of the refrigerator.
LOWER VENT CUTOUT
13-5/8”
28-5/
8”
Lower vent cutout
Ventilation
heigh
t
Condenser
The upper vent should be
centered over the condenser coil
at the back of the refrigerator.
Certifi ed vent system kits
Kit no.
Components
Part no.
5A
Roof Base
Roof Cover
Lower Side Vent
Power Vent Asm.
3103633.XXX*
3103634.XXX*
3109349.XXX*
3108705.744**
*
Fill in “XXX” with color code numbers. For color codes, contact
your supplier.
** Alternate instructions forwarded with the Ventilator Kit.
The appliance is certifi ed under the latest edition of ANSI Z21.19•CSA 1.4 Refrigerators using gas fuel. The installation must
conform with local codes, or in absence of local codes, the following standards as applicable.
In the U.S. the installation must conform with:
National Fuel Gas Code, ANSI Z223.1/NFPA 54 (latest edi-
tion).
Recreational Vehicles Code, ANSI A119.2 (latest edition)
Manufactured Home Construction and Safety Standard, Title
24 CFR, Part 3280.
If an external electrical source is utilized, the refrigerator, when
installed, must be electrically grounded in accordance with lo-
cal codes or, in the absence of local codes, the National Electri-
cal Code, ANSI/NFPA 70 - (latest edition).
•
•
•
In CANADA, the installation must conform with:
Natural Gas and Propane Installation Code, CSA B149.1
CSA Z240 RV Series, Recreational Vehicles.
Current CSA Z240.4, Gas-equipped Recreational Vehicles
and Mobile Housing.
If an external electrical source is utilized, the refrigerator,
when installed, must be electrically grounded in accordance
with local codes or, in the absence of local codes, the Canadian
Electrical Code, CSA C22.1, Parts I and II - (latest edition).
•
•
•
CERTIFICATION AND CODE REQUIREMENTS