User manual

5.2. Operating from 12 Volt

vehicle battery

Make sure the voltage shown on the data plate of

the appliance matches the voltage of the vehicle

battery (12V).

In 12V operation, the appliance runs continuously

without temperature control.

The appliance is supplied with a matching

pair of 12 Volt MALE + FEMALE plugs (see

9,2 connection to vehicle power source).

For 12V operation, make sure, if the engine is not

running, the plug must be disconnected (see

fig.7). Otherwise, the appliance will discharge the

vehicle battery when in operation.

5.3. Operating from bottled gas

Connection to the gas cylinder is described in

sections 9.3. and 9.4.

After opening the valve of the gas cylinder and

checking for gas leaks turn thermostat to

maximum position (Figure 4), press down the gas

safety valve hold it down for about 10 seconds and

then, press the piezo-ignition button (marked with

a star) several times in quick succession. If the

flame does not ignite, repeat the process. (Air in

the appliance gas line prior to connection to the

gas cylinder must be purged. Only then can the

gas be lit.)

Ignition of the flame can be verified through the

flame-view opening (Figure 5). After you have the

flame alight keep the safety gas valve pressed

down for a further 10 seconds.

To stop the gas operation the valve of the gas

cylinder (or the pressure regulator) is the close.

Figure 3.

Figure 4.

Figure 5.