SuperCooler RC 4000 0402 Operating Instructions 207.5331.
Please read these operating instructions carefully before using the product. If you later sell or dispose of it, please ensure that the new owner receives these operating instructions. Thank you for choosing our appliance. We are sure it will provide you with trouble-free service.
CONTENT S 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. Unpacking View of the appliance Cleaning Positioning the appliance Using the appliance 5.1. From electrical mains 5.2. From vehicle battery 5.3. From bottled gas Mounting the wheels Making ice Useful suggestions Defrosting, cleaning and maintenance Warranty and customer service Putting into operation, technical data 11.1. Connecting to electrical mains 11.2. Connecting to vehicle power supply 11.3. Connecting to bottled gas cylinder 11.4.
1. Unpacking After removal from the cardboard packaging, make sure the appliance is not damaged. If you find damage to the appliance resulting from transport, report it immediately to the transportation firm. 2. View of the appliance 3 5 7 2 4 9 6 1 8 Figure 1. 1. Insulated casing 6. Rear cover 2. Insulated lid 7. Ice-tray shelf 3. Pull handle 8. Wheels 4. Control panel 9. Storage net 5.
3. Cleaning Clean both the inside and outside of the appliance before putting it into use. To do so, use a soft towel, lukewarm water and a non-abrasive detergent. Ensure water does not enter the rear cover grille or the control elements. Afterwards, wipe the appliance with a clean towel and clean water, and then wipe it dry. To avoid damage, do not use soap, soda or abrasive cleaners. 4.
5.2. Operating from vehicle battery Make sure the voltage shown on the data plate of the appliance matches the voltage of the vehicle battery (12V or 24V). 12V DC voltage appliances are equipped with connectors that can be plugged into cigarette lighters (Figure 3.). For some types of vehicles, you may need to remove the red plastic ring located on the end of the connector. To do so, turn the plastic ring anticlockwise and pull it off. The appliance can then be connected to the cigarette lighter.
. Making ice The ice-tray holder and ice-tray accessories delivered with the appliance allow ice cubes to be made. To do so, first insert the ice-tray holder panel into the groove of the plastic holder. Make sure the perforated part of the panel enters the groove (Figure 6). Next, fill the ice tray with water (up to about 4 mm below the edge) and put on the cover. Figure 6. Place the ice tray on the ice-tray holder, so that its outer edge is below the edge of the plastic cover (Figure 7).
Removal of the storage net the cleaning: Te 5 pcs plastic rivetsshould be pulled out by pressing the central shift by approx. 5mm (by means of a pen) (figure 8), then the plastic rivets should be removed. Before fixing the net the pressed shifts of the plastic rivets should be fully pressed back. (till click) (figure 9). Figure 8. Figure 9. The protruding ends of the placed back plastic rivets should be hit in. 10.
Electrical Requirements Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance data plate. Only for UK: The appliance is supplied with a 3 amp plug fitted. In the event of having to change the fuse in the plug supplied, a 3 amp ASTA approved (BS 1362) fuse must be used.
seal Figure 10. For your safety: Do not check for leaks with a naked flame! 12. Environmental protection information The appliance does not contain any CFCs/HCFCs. Ammonia (natural hydrogen and nitrogen compound) is used as refrigerant agent in the cooling unit. The ozone-friendly cyclopentane is used as a blowing agent for the PU foam insulation. Sodium chromate is used for corrosion protection (less than 2 weight % of the coolant). 13.
Printed by Xerox Hungary Ltd. Rev.: 2003. 12. 19.
