Installation and Operation Instructions

ManualsBrandsDometic ManualsElectronics17keys RGB controller

AWNINGS

RGB LED Controller & RF Wireless Remote

Installation and Operation Instructions . . . . . .1

1 Features

• 22 Dynamic Modes • Card Type RF Remote

• 20 Static Colors • Ultra Slim Design

• Very Smooth Eﬀects • Dynamic Demo Mode

• Adjustable Speeds • Easy Remote Pairing

• Adjustable Brightness • Direct Color Select

2 Installation

This section provides the installation information for the RGB LED.

2.1 Power Supply

This unit accepts 11 VDC to 14 VDC power supply. The DC

plug’s inner pole (or red cable) is positive and sleeve (or black

cable) is negative.

2.2 LED Output

This unit supports common anode connection LED products.

The peak output current is 6 A and maximum rated current

is 3 A per channel. Please reduce the load if the main unit is

overheating.

NOTICE: Do not short circuit or overload the outputs, this

may lead to permanent damage.

3 Operation

This section provides the information for the operation of the

remote controller and the RGB LED.

3.1 Using the Remote Controller

Remove the battery insulation tape before using. The RF

Wireless remote signal can pass through barriers, and it is not

necessary to aim at the main unit during operation. Do not

install the main unit in closed metal areas.

3.2 Pairing a New Remote

The remote and main unit is not paired as default. The main

unit can be paired to any remote controller and each remote

controller can be paired to any main unit. To pair a new remote

controller:

1. Turn the power oﬀ to the main unit. Wait 10 seconds. Turn

the power to the main unit on.

2. Press the COLOR – and BRIGHT – keys together within 10

seconds aer returning power to the main unit. Hold the

buttons down until the LED light ﬂashes brieﬂy. Pairing is

now complete.

Aer this operation, the main unit will recognize the new

remote controller

3.3 Cold Weather Use

In temperatures below 50°F (10°C), there may be a

discoloration of the white light. The light will return to normal

when the temperature increases.

FCC ID: 2AUML-RF17

Summary of content (3 pages)

PAGE 1
2.2 LED Output AWNINGS This unit supports common anode connection LED products. The peak output current is 6 A and maximum rated current is 3 A per channel. Please reduce the load if the main unit is overheating. NOTICE: Do not short circuit or overload the outputs, this may lead to permanent damage. 3 Operation This section provides the information for the operation of the remote controller and the RGB LED. 3.
PAGE 2
4 Functions 7/8. Brightness Adjustment Adjust the static color brightness. Press BRIGHT+ to increase brightness and press BRIGHT– to decrease. The unit will switch to static color mode if you press this key at dynamic mode. q e 10. Demo Mode MODE w + SPEED DEMO SPEED r COLOR MODE BRIGHT t COLOR + + + BRIGHT 1! 1) i o u y Press this key to switch to Demo Mode. At Demo Mode, the unit will play 17 dynamic modes in loop, each mode repeating 3 times.
PAGE 3
FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.