User manual

7
This refrigerator is equipped with overheating protection.
An authorised service technician can check whether this
has been triggered or not.
In the event of a fault developing, contact your nearest
Service Centre-see local telephone directory.
13. Putting into operation
Technical data:
13.1. Connecting to electrical mains
The appliance may only be operated from
nominal voltage mains as shown on the data
plate. The appliance mains plug may be connected to a
mains socket earthed in accordance with regulations.
Any electrical work required to install this appliance
should be carried out by a qualified electrician or
competent person.
The manufacturer declines any liability should
these safety measures not be observed.
Electrical Requirements
Before switching on, make sure the electricity supply
voltage is the same as that indicated on the appliance
rating plate.
Only for UK:
The appliance is supplied with a 3 amp plug fitted.
In the event of having to change the fuse in the plug
supplied, a 3 amp ASTA approved (BS 1362) fuse
must be used. Should the plug need to be replaced
for any reason, the wires in the mains lead are
coloured in accordance with the following code:
Green and Yellow: Earth
Blue: Neutral
Brown: Live
The wire coloured green and yellow must be
connected to the terminal marked with the letter „E“
or by the earth symbol or coloured green and
yellow.
insert the new panel (7), so that the upper edge of the panel
runs exactly parallel to the upper edge of the frame. A new
panel can be inserted more easily into the upper edge of
the frame when the two corners are cut off by approx. 5 x
5 mm (8). Put the frame edge (5) back in place and secure
with screws.
Place the door on the lower hinge (9), slot the upper hinge
into the opening, press together with the door against the
housing and secure with the two screws (11).
Figure 9.
Figure 10.
Figure 11.
12. Customer service
Before you call a service engineer, carry out the following
simple tests:
Is there a power failure? Check the fuses.
Is the plug firmly connected to the socket and is the
socket switched on? Check the socket by plugging in
another appliance, e.g. a table lamp.
Is the thermostat at the correct setting? (normally 2 or 3).
Has the door not been closed properly causing the
inside temperature to rise too quickly?
Is the refrigerator level?
Has the ventilation become obstructed?
If after checking all the above points, the refrigerator is still
not working satisfactorily, contact your nearest service
engineer. State the problem, model, product- and serial-
number.
(Details of the model, product- and serialnumber are to be
found on the data label in the top left of the inside
compartment.)
Model RH 161
Type MF20-60
Gross volume 60 liter
Mains operation 220-240V (AC)
Input 115W
Energy consumption 1.4 kWh/24h
Climate class N
Refrigerant 357g H
2
O+168g NH
3