miniBar RH 439LD Type: MB20-60 Free-standing and Built-in versions Operating instructions 207.5396.
Please read these operating instructions carefully before putting the refrigeration unit into operation. If you later sell or dispose of it, please ensure that the new owner receives these operating instructions. Please follow the installation details below carefully. Guarantee is valid for products installed as described only. (See chapter 4.1.) Thank you for choosing our appliance. We are sure it will provide you with trouble-free use.
CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. Unpacking View of the appliance Cleaning Positioning the appliance 4.1. Installation instruction 4.1.1. Built-in version 4.1.2. Free-standing version Using the appliance 5.1. Initial operation 5.2. Temperature regulation Ice cubes Useful suggestions Defrosting, cleaning and maintenance 8.1. Automatic defrost function 8.2.
1. Unpacking After removal from the cardboard packaging, make sure the appliance is not damaged. If you find damage to the appliance resulting from transport, report it immediately to the transportation firm. 2. View of the appliance Built-in version Free-standing version Figure 1. 1. 2. 3. 4. 5. 6. Door Door lock (if available) Ice tray Lamp Evaporator cover Evaporator 7. 8. 9. 10. 11.
3. Cleaning Clean the refrigerator thoroughly at intervals, as necessary. Remove the shelves; these, parts, as well as the cabinet interior and the door should be washed with a warm solution of sodium bi-carbonate. Finally wipe over with a cloth rinsed in warm water only, and dry with a clean cloth. Do not wash any plastic parts in water that is more than hand warm, and do not expose them to dry heat. The outside of the cabinet should be wiped down regularly with a clean, damp cloth.
D C 7. Useful suggestion Air out Do not overfill the appliance. If possible, always store pre-cooled food and/or drinks. It is advisable to leave some space between the products in the cabinet to ensure efficient and even cooling. If the shelves are packed too tightly there may be unacceptable temperature variations. min. 60 mm Air out Ventilation grille miniBar miniCool miniBar miniCool Air in Air in Figure 4. During installation, please ensure the mains plug is accessible at all times. 4.1.2.
10. Replacing the decorative door panel (Fig. 7., 8.) B A Figure 6. 9. Reversing the door hang (Fig. 7.) Reversing is suggested to perform in the following way, in order to avoid breaking of the hinge bolt: Disconnect the mains Lay the appliance down carefully on its back 7 5 (only freestanding model) Removing and mounting of the door is similar to that of described in the previous, 9 chapter. (Only the foot on the hinge-side has to be removed!) Remove screws (4) and pull off the frame edge (5).
11. Customer service Before you call a service engineer, carry out the following simple tests: Problem Possible cause The appliance does not cool sufficiently Too much food to be cooled was put in. Door is not shut properly. Internal air circulation is restricted. Refrigerator not level. The appliance does not cool at all and Plug is not connected to the mains socket there is no lighting at all properly There is no voltage in the mains socket.
Printed by Océ Hungária Kft. 2007. 01. 31.
