User manual

- 7 -

Be careful when installing the refrigerator models
NDM1062 & NDR1292. These are equipped with the
latest vacuum insulated panel technology. The insu-
lating panels are located on the top, back, bottom,
sides and doors. If the surface is punctured, loss of
insulation will occur, resulting in poor refrigerator
performance.
For a proper installation, follow these instructions:

The refrigerator must be level and installed in a substantial 
enclosure.
Do not install the appliance directly on carpeting. Carpet-
ing must be removed or protected by a metal or wood panel
beneath the appliance, which extends at least full width and
depth of the appliance.



 must be in place across the up-
per opening of the enclosure. The top frame
of the refrigerator will be anchored to the
wood strip with screws.
When installing the refrigerator in the enclosure, all areas 
within the recess have to be sealed. Verify that there is a
complete seal between the front frame of the refrigerator and
-
ing strip is applied to the rear surface of the front frame for
this purpose. The sealing strip should provide a complete

vehicle interior.
 and 




It is important to follow the sequence in securing refrigerator
in enclosure since failure in doing so can cause leakage be-

storage area or ceiling and top of the refrigerator greater than
1 1/2 inches should be blocked. The heat produced at the rear
of the refrigerator will become trapped in this space, making

refrigerator.

seal at the front frame), the refrigerator is to be secured in the
enclosure with screws (not included).
RM2351 & RM2354

Four screws installed through the front frame. 1.
(To cover the screw heads, use the plugs in the parts
bag.)
One screw installed in the rear base. 2.
2
1
General view. Features may vary according to model.




7OODSTRIP
installation procedure