User manual
- 6 -
INSTALLATION INSTRUCTIONS
INSTALLING REFRIGERATOR
The refrigerator must be installed in a substantial enclosure
and must be level.
-
ing must be removed or protected by a metal or wood panel
beneath the appliance, which extends at least full width and
depth of the appliance.
installed must be sealed. Make sure that there is a complete
seal between the front frame of the refrigerator and the
strip is applied to the rear surface of the front frame for this
the enclosure. The sealing should provide a complete isola-
tion of the appliance’s combustion system from the vehicle
interior. Be careful not to damage the sealing strip when the
SECURING THE REFRIGERATOR
It is important to follow the sequence in securing refrigerator in
enclosure since failure in doing that can cause leakage between
The heat produced at the rear of the refrigerator will become
trapped in this space, making the top of the refrigerator hot and
Install the six screws in the following order:
Two screws installed through the front base.
Two screws installed in the top frame.
Two screws installed in the rear base.
CONNECTIONS
GAS CONNECTION
Hook up to the gas supply line is accomplished at the manual
checked for leaks with a non-corrosive commercial bubble
solution
2.
3 rd.
2 nd.
1 st.
The gas supply system must incorporate a pressure regulator
column. When testing the gas supply system at test pressures:
> 1/2 psi - the refrigerator and its individual shutoff valve
must be disconnected from the gas supply piping system.
- the appliance must be isolated from the gas sup-
ply piping system by closing its individual manual shutoff
valve.
If detailed instructions on the installation and connection to the
gas supply are required, contact your dealer or distributor.
•
•
EXPLOSION HAZARD. Never use an open
warning could cause an explosion resulting in
death or severe personal injury.
WARNING
!