User manual

- 8 -
MOUNTING THE DOOR PANEL
The refrigerator is normally delivered without door panel. Be-
fore mounting the door panel, read this instruction thoroughly
and check that the panel dimensions are in compliance with
those given in the table below.
Panel dimensions
max. thickness 5/32" (4 mm)
Model Height
max min
Width
max min

mm
   
inch
   

mm
   
inch
   
To mount the panel, follow these steps:

On new refrigerators, the decoration strip is taped
inside the door; if installed on the door, remove


Insert one vertical edges into the groove of the door

Bend the panel gently so that the free side of the
panel can be slipped into the corresponding groove


Between the upper edge of the panel and the door
frame there is a gap which should be covered by the
decoration strip.



the door frame.
Secure the decoration strip with the two screws


2.



6.
MOUNTING INSTRUCTIONS
1
1
2
3
4
5
6
1
1