User manual

- 7 -
model equiPPed with dooR inseRt Panels
Reversing the door swing
The refrigerator is equipped with hinges that makes it possible
to change the direction the door opens by moving the hinges
to the opposite side. A special hinge kit must be used in order
to change the door swing. For spare part numbers, refer to the
USER MANUAL, APPENDIX A - SPARE PARTS. For additional
information, please contact service point or distributor service
dept. for assistance.
Installing the door panels
The refrigerator is delivered without door panel(s). Before
starting the mounting work, read this instruction thoroughly
and check that the panel dimensions are in compliance with
those given in the table below.
Panel dimensions
max. thickness 5/32" (4 mm)
Model Height
max min
Width
max min
RM3762
upper
inch
17-3/64 16-31/32 23-25/32 23-11/16
mm
433 431 604 602
lower
inch
32-7/16 32-23/64 23-25/32 23-11/16
mm
824 822 604 602
RM3962
upper
inch
17-3/64 16-31/32 23-25/32 23-11/16
mm
433 431 604 602
lower
inch
41-39/64 41-9/16 23-25/32 23-11/16
mm
1057 1055 604 602
mounting instRuctions
model equiPPed with steel dooRs
Mounting the door handles
To mount the handles, follow these steps:
Snap on the handle by inserting its two tabs in the
slot and slide into place.
Attach the handle with two screws.
1.
2.