Operation Manual

Installation recess

The refrigerator must be installed draught-free in a recess.

The measurements of the recess are given in the table below.

Step (A) is only required for cabinets with a step. Push the appliance far enough into

the recess until the front edge of the refrigerator casing is flush with the front of the

recess. Allow a gap of 15-20 mm between the back wall of the recess and the

refrigeration unit. The floor of the recess must be level, allowing the appliance to be

pushed easily into its correct position. The floor must be substantial enough to bear the

weight of the appliance.

Ensure that the refrigerator is installed level in the recess.

Recess measurements:

Model Hight H Width W Depth T Hight HSt Depth TSt

RM 7290 825 mm 529 mm 515 mm 220 mm 235 mm

RM 7400 825 mm 529 mm 515 mm - -

Securing the refrigerator

In the sidewalls of the refrigerator, there are four plastic

sleeves with screws for securing the refrigerator. The

sidewalls or rails attached for securing the refrigerator

must be designed in such a way that the screws will

remain firmly in place even when under increased load

(while the vehicle is moving).

Always insert screws through the sleeves provided;

otherwise, structural parts embedded in the foam,

such as cables, etc., may be damaged.

Once the refrigerator is in its final position, secure the

screws into the wall of the recess.

The screws must penetrate through the sheet metal

casing of the refrigerator.

6.5

Width of recess = W

6.6