User manual

Defrosting
As time goes by, frost builds up on the fins.
When the layer of frost is about 3mm thick, the refrigerator should be defrosted.
1. Switch off the refrigerator, as described in section 5.3 - "Switching off".
2. Remove the ice cube tray and food.
3. Leave the refrigerator door open.
4. After defrosting (freezer compartment and fins free of frost), wipe the
cabinet dry with a cloth.
5. Use a cloth to mop up the water from the freezer compartment.
6. Switch the refrigerator on again.
The layer of ice must never be removed forcibly, nor may defrosting be
accelerated using a heat source.
Note:
Water thawing in the main compartment of the refrigerator runs into an appropriate
container at the back of the refrigerator. From there, the water evaporates.
Winter Operation
Roof mounted flue outlet
Before the appliance is put into operation at the
gas mode the area around the flue outlet has to be
free of ice and snow or leaves. Periodically, check the
flue outlet. A layer of ice should be formed by conden-
sing water (from exhaust fumes).
Switching Off
10
5.5
5.6
5.7
Do not step on
flue outlet !
2. When the refrigerator is shut off for a long
period, leave the door ajar.
RM 7211 LSC
RM 7401 LSC
1. Set energy selector switch (A) to position (OFF).
The appliance is now fully switched off.
3. Secure the door open by means of the door
stop. The door will be slightly ajar. This is
to prevent mould from forming inside
the appliance.
A
Switching off gas operation
If the refrigerator is to be taken out of service for an extended period of
time, the on-board gas cock and the cylinder valve must be closed.