User manual
23
Rear installation
If the refrigerator is mounted at the rear of the vehicle
unit.
8.1.2
8.2
Rear installation often causes an unfavourable installa-
tion arrangement, as ideal ventilation cannot always be
assured (e.g. the lower ventilation grille is covered by
the bumper or the rear lights of the vehicle!) (Fig. 4).
The maximum cooling performance of the aggregate is
actually not available.
Another variant of the rear installation is the side instal-
lation of the ventilation grilles (fig. 5). The air-heat recir-
culation is very restricted which means the heat
exchangers (condenser, absorber) cannot be adequa-
tely cooled. The variant with an additional ventilation grille mounted in the floor also
has a bad airflow duct.
Air vent grille not
blocked ! OK!!
Fig.3
The maximum cooling performance is not available! Please assure at all the
installation variations correct ventilation and extraction, as described in item
8.4! Any installation that is not carried out by qualified persons will jeopardize
the manufacturer's guarantee.
Installation recess
The refrigerator must be installed draught-free in a recess (see point “8.3”).
The measurements of the recess are given in the table below. Step (A) is only
required for cabinets with a step. Push the appliance far enough into the recess
until the front edge of the refrigerator casing is flush with the front of the recess.
Allow a gap of 15-20 mm between the back wall of the recess and the refrigeration
unit. The floor of the recess must be level, allowing the appliance to be pushed
easily into its correct position. The floor must be substantial enough to bear the
weight of the appliance.
Ensure that the refrigerator is installed level in the recess.
Stopper strips for example are affixed in the installa-
tion bay, at the sides, at the bottom and at the top
and are fitted with flexible sealant strips.
Affix strip to side wall.
Seal i.e.V seal.
H
T
Recess dimensions:
Model Height H
min
Width B Depth T
min
RMT 7650 1685 mm 530 mm 510 mm
RMT 7651 1685 mm 530 mm 510 mm
RMT 7655 1685 mm 530 mm 510 mm
RMT 7850 1685 mm 530 mm 565 mm
RMT 7851 1685 mm 530 mm 565 mm
RMT 7855 1685 mm 530 mm 565 mm
plan view