Installation Manual
EN
Installing the refrigerator RUC5208X, RUC6408X, RUC8408X
18
– Push the bottom trim piece with the four plugs (fig. a 1) into the holes on the
front frame of the refrigerator.
– Snap the three catches (fig. a 2) into the holes under the bottom frame of
the refrigerator.
7.3 Installing the drain water hose
➤ To avoid damage to the drain water hose, position the hole for the drain water
hose in a way that the hose does not kink.
➤ Drill a hole through the vehicle floor at the rear of the refrigerator.
➤ Install the drain water hose through the drilled hole. Ensure that the drain water
hose is long enough in order to drain the water outside of the vehicle.
➤ DO NOT shorten the drain hose. The excess length will enable partial extraction
of the refrigerator if required for service access.
➤ Ensure that the drain water hose is not kinked.
➤ Seal the area around the drain water hose.
a
1
2
RUC8408X--IO-AU.book Seite 18 Montag, 8. Juli 2019 1:56 13