User Manual

Installing the toilet Saneo B, Saneo C

5.3 Setting up the toilet

➤ Install the toilet according to the description for the respective model version.

➤ Set up the toilet so that it is flush to a vertical wall only.

➤ Leave at least 60 mm space to the side walls so that the swivelling of the upper

part of the toilet (with seat) is not restricted.

➤ For the installation, use the dimensional drawings and templates:

– Saneo B, Saneo C: fig. 4, page 5

– Saneo BS, Saneo CS: fig. 5, page 6

– Saneo BW, Saneo CW: fig. 5, page 6

– Saneo BLP, Saneo CLP: fig. 6, page 7

– Milling dimensions: fig. 7, page 8

– Drill holes: fig. 8, page 9

– Radii: fig. 9, page 10

5.4 Setting up the Saneo B, Saneo C toilet

The freestanding models Saneo B and Saneo C have no integrated water tank. Set

up this model so that the wall behind it can accommodate the control unit of the

toilet, the electrical connections and possibly a water tank. It is ideal if you put a box

in front of the room wall (fig. 0, page 11).

NOTICE!

All components of the system must be installed in frost-free areas.

In freezing temperatures, there is a risk of damage caused by frost.

NOTE

•

For the templates for milling dimensions, drill holes and radii,

observe the symmetry point of the toilet (fig. 7 A, page 8,

fig. 8 A, page 9, fig. 9 A, page 10).

•

When installing the toilet in a wet room, the manufacturer recom-

mends that you connect the toilet to the shower tray.

NOTE

Exemplary installation in a shower tray is shown in fig. 0, page 11 and

fig. a, page 11.

Saneo-B-Saneo-C--I-18s.book Seite 26 Montag, 9. April 2018 6:44 06