Product Manual
EN
SKL101, SKS101 Using the slide out kitchen
11
➤ Ignite the burner using a long match or another suitable ignition device. Remove
your hand as soon as the burner is lit.
✓ The burner ignites.
➤ Hold down the control knob for a few seconds to make sure that the flame does
not go out.
➤ Adjust the flame so it does not extend beyond the edge of the pot.
7.4 Switching off the cooktop
➤ Set the knob to the zero setting .
✓ The burner goes out.
➤ Close the gas cylinder valve if you will not be using the gas cooktop for an
extended period.
7.5 Replacing the gas cylinder
!
➤ Switch all burners off by turning the control knobs to the zero setting.
➤ Completely close the valve on the gas cylinder.
➤ Screw the pressure reducing valve off the gas cylinder.
➤ Check the condition of the hose line.
➤ Replace the hose line if the material is brittle or porous.
➤ Tightly screw the pressure reducing valve onto the new cylinder.
➤ Open valve on gas cylinder.
➤ Check with leak spray. Confirm that no bubbles form (no leaks).
➤ Close the valve on the gas cylinder.
7.6 Attaching accessories
➤ Mount the accessory parts as shown (fig. 2, page 6).
WARNING! Beware of injury!
•
When changing the gas cylinder, make sure that there are no sources
of ignition nearby. Only change the gas cylinder when the burner is
switched off.
•
Never check for leaks with an open flame or near sources of ignition.
SKL101_SKS101-O-AUS.book Seite 11 Donnerstag, 18. Oktober 2018 10:52 10