Product Manual

EN
TEC29 EV AUS Installation
15
8.3 Securing the silencer
Observe the following instructions when installing the exhaust pipe:
• Do not create any sharp bends which will inhibit the flow of exhaust fumes.
• Align the manifold (fig. 7 1) along the housing to ensure greater damping of
vibration.
• Use the exhaust pipe extension to extent the exhaust pipe (fig. 7 2) (see
chapter “Accessories” on page 8).
Secure the extension to the vehicle floor (fig. 7 3) according to ADR 42.8.
• If cutting the exhaust pipe, wear protective gloves and be careful of sharp edges.
➤ Secure the silencer (fig. 7 4) as in one of the alternatives shown in fig. 8,
page 16 to fig. b, page 17.
Washers, brackets and screws are not included in the scope of delivery.
1
2 3 4
7
TEC29EV-IO-AUS.book Seite 15 Montag, 6. März 2017 8:37 20