Product Manual
EN
TEC29 EV AUS Connecting the electrical power to the generator
25
➤ Connect the negative terminal of the battery using a cable with a suitable cross-
section (see above) via the insert of the generator (fig. g 1).
➤ Connect the earth connection on the generator to the vehicle chassis.
Remove any paint or rust from the chassis if necessary to ensure good contact.
➤ Protect the connections by applying lubrication.
9.5 Configuring the automatic mode
I
In automatic mode, the generator switches on automatically and charges the battery
if the voltage of the connected battery is too low.
NOTE
• You can only use automatic mode:
– if the vehicle is stationary and the ignition is switched off
• To shorten charging times, an additional charging unit with at least
20 A can be installed between the generator and disconnector
switch, especially if batteries with a capacity of more than 60 Ah are
used. In this case remove the fuse (fig. f 3, page 23) from the
internal control panel.
1
g
TEC29EV-IO-AUS.book Seite 25 Montag, 6. März 2017 8:37 20